On Sat, May 30, 2020 at 11:05:54PM +0200, Wolfram Sang wrote: > On Sat, May 30, 2020 at 01:09:30PM +0200, Wolfram Sang wrote: > > On Thu, May 28, 2020 at 12:33:18PM +0300, Serge Semin wrote: > > > Seeing the DW I2C driver is using flags-based accessors with two > > > conditional clauses it would be better to replace them with the regmap > > > API IO methods and to initialize the regmap object with read/write > > > callbacks specific to the controller registers map implementation. This > > > will be also handy for the drivers with non-standard registers mapping > > > (like an embedded into the Baikal-T1 System Controller DW I2C block, which > > > glue-driver is a part of this series). > > > > > > As before the driver tries to detect the mapping setup at probe stage and > > > creates a regmap object accordingly, which will be used by the rest of the > > > code to correctly access the controller registers. In two places it was > > > appropriate to convert the hand-written read-modify-write and > > > read-poll-loop design patterns to the corresponding regmap API > > > ready-to-use methods. > > > > > > Note the regmap IO methods return value is checked only at the probe > > > stage. The rest of the code won't do this because basically we have > > > MMIO-based regmap so non of the read/write methods can fail (this also > > > won't be needed for the Baikal-T1-specific I2C controller). > > > > > > Suggested-by: Andy Shevchenko <[email protected]> > > > Signed-off-by: Serge Semin <[email protected]> > > > Tested-by: Jarkko Nikula <[email protected]> > > > Acked-by: Jarkko Nikula <[email protected]> > > > Cc: Alexey Malahov <[email protected]> > > > Cc: Thomas Bogendoerfer <[email protected]> > > > Cc: Rob Herring <[email protected]> > > > Cc: [email protected] > > > Cc: [email protected] > > > > My codecheckers found these, rightfully I'd say: > > > > SPARSE > > drivers/i2c/busses/i2c-designware-master.c:427:53: warning: incorrect type > > in argument 3 (different signedness) > > drivers/i2c/busses/i2c-designware-master.c:427:53: expected unsigned int > > *val > > drivers/i2c/busses/i2c-designware-master.c:427:53: got int * > > > > CC > > drivers/i2c/busses/i2c-designware-common.c:127: warning: Excess function > > parameter 'base' description in 'i2c_dw_init_regmap' > > > > ^ means there is an argument documented which does not exist in the > > function declaration > > Well, I fixed these two minor things for your now... >
Great! Sorry for me not doing it on time. I was away from my laptop and internet last day to do that. I saw your message about the sparse detecting the problems while I was on my way to outskirts and was going to fix them today either in a new version of the patchset or sending follow-up patches. But you already fixed the problems. Thank you very much for doing that for me. -Sergey
