Using full paths to extend or override a device tree node is error prone since if there was a typo error, a new node will be created instead of extending the node as it was desired. This will lead to run-time errors that could be hard to detect.
A mistyped label on the other hand, will cause a dtc compile error (during build time). Signed-off-by: Krzysztof Kozlowski <[email protected]> --- arch/arm/boot/dts/exynos5250.dtsi | 38 +++++++++++++++---------------- 1 file changed, 18 insertions(+), 20 deletions(-) diff --git a/arch/arm/boot/dts/exynos5250.dtsi b/arch/arm/boot/dts/exynos5250.dtsi index 0249d16e187f..488d3f9fab59 100644 --- a/arch/arm/boot/dts/exynos5250.dtsi +++ b/arch/arm/boot/dts/exynos5250.dtsi @@ -1085,26 +1085,6 @@ }; }; - thermal-zones { - cpu_thermal: cpu-thermal { - polling-delay-passive = <0>; - polling-delay = <0>; - thermal-sensors = <&tmu 0>; - - cooling-maps { - map0 { - /* Corresponds to 800MHz at freq_table */ - cooling-device = <&cpu0 9 9>, <&cpu1 9 9>; - }; - map1 { - /* Corresponds to 200MHz at freq_table */ - cooling-device = <&cpu0 15 15>, - <&cpu1 15 15>; - }; - }; - }; - }; - timer { compatible = "arm,armv7-timer"; interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>, @@ -1120,6 +1100,24 @@ }; }; +&cpu_thermal { + polling-delay-passive = <0>; + polling-delay = <0>; + thermal-sensors = <&tmu 0>; + + cooling-maps { + map0 { + /* Corresponds to 800MHz at freq_table */ + cooling-device = <&cpu0 9 9>, <&cpu1 9 9>; + }; + map1 { + /* Corresponds to 200MHz at freq_table */ + cooling-device = <&cpu0 15 15>, + <&cpu1 15 15>; + }; + }; +}; + &dp { power-domains = <&pd_disp1>; clocks = <&clock CLK_DP>; -- 2.17.1
