On Thu, Sep 17, 2020 at 08:54:46PM +0200, Krzysztof Kozlowski wrote: > GPIO_ACTIVE_x flags are not correct in the context of interrupt flags. > These are simple defines so they could be used in DTS but they will not > have the same meaning: > 1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE > 2. GPIO_ACTIVE_LOW = 1 = IRQ_TYPE_EDGE_RISING > > Correct the interrupt flags, assuming the author of the code wanted same > logical behavior behind the name "ACTIVE_xxx", this is: > ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW > > Signed-off-by: Krzysztof Kozlowski <[email protected]>
Applied all, thanks.
