On Fri, Jan 1, 2021 at 9:43 PM Jonathan Neuschäfer <j.neuschae...@gmx.net> wrote: > > Currently the HTML output for Documentation/driver-api/gpio/intro.rst > doesn't look right. The lines that start with LOW or HIGH are formatted > in bold, while the next line after each is not bold. > > With this patch, the HTML looks better. > > Signed-off-by: Jonathan Neuschäfer <j.neuschae...@gmx.net> > --- > Documentation/driver-api/gpio/intro.rst | 8 ++++---- > 1 file changed, 4 insertions(+), 4 deletions(-) > > diff --git a/Documentation/driver-api/gpio/intro.rst > b/Documentation/driver-api/gpio/intro.rst > index 74591489d0b55..94dd7185e76eb 100644 > --- a/Documentation/driver-api/gpio/intro.rst > +++ b/Documentation/driver-api/gpio/intro.rst > @@ -106,11 +106,11 @@ don't. When you need open drain signaling but your > hardware doesn't directly > support it, there's a common idiom you can use to emulate it with any GPIO > pin > that can be used as either an input or an output: > > - LOW: gpiod_direction_output(gpio, 0) ... this drives the signal and > overrides > - the pullup. > + **LOW**: ``gpiod_direction_output(gpio, 0)`` ... this drives the signal and > + overrides the pullup. > > - HIGH: gpiod_direction_input(gpio) ... this turns off the output, so the > pullup > - (or some other device) controls the signal. > + **HIGH**: ``gpiod_direction_input(gpio)`` ... this turns off the output, so > + the pullup (or some other device) controls the signal. > > The same logic can be applied to emulate open source signaling, by driving > the > high signal and configuring the GPIO as input for low. This open drain/open > -- > 2.29.2 >
Applied, thanks! Bartosz
