On 2/10/21 10:47 AM, Dave Hansen wrote:
On 2/10/21 2:21 AM, Joerg Roedel wrote:
+ /* Store to memory and keep it in the registers */
+ movl %eax, rva(sev_check_data)(%ebp)
+ movl %ebx, rva(sev_check_data+4)(%ebp)
+
+ /* Enable paging to see if encryption is active */
+ movl %cr0, %edx /* Backup %cr0 in %edx */
+ movl $(X86_CR0_PG | X86_CR0_PE), %ecx /* Enable Paging and Protected
mode */
+ movl %ecx, %cr0
+
+ cmpl %eax, rva(sev_check_data)(%ebp)
+ jne 3f
+ cmpl %ebx, rva(sev_check_data+4)(%ebp)
+ jne 3f
Also, I know that turning paging on is a *BIG* barrier. But, I didn't
think it has any effect on the caches.
I would expect that the underlying physical address of 'sev_check_data'
would change when paging gets enabled because paging sets the C bit.
So, how does the write of 'sev_check_data' get out of the caches and
into memory where it can be read back with the new physical address?
I think there's some bit of the SEV architecture that I'm missing.
Non-paging memory accesses are always considered private (APM Volume 2,
15.34.4) and thus are cached with the C bit set.
Thanks,
Tom
