Linux 2.6.24 kernel gives the following messages when udev coldplugging
loads the driver for my NIC:
8139too 0000:00:0b.0: This (id 10ec:8139 rev 20) is an enhanced 8139C+ chip
8139too 0000:00:0b.0: Use the "8139cp" driver for improved performance and
stability.
ACPI: PCI Interrupt Link [LNK1] enabled at IRQ 10
ACPI: PCI Interrupt 0000:00:0b.0[A] -> Link [LNK1] -> GSI 10 (level, low) ->
IRQ 10
8139too 0000:00:0b.0: unknown chip version, assuming RTL-8139
8139too 0000:00:0b.0: TxConfig = 0x74800000
eth1: RealTek RTL8139 at 0xcee8e800, 00:08:02:d8:d5:b9, IRQ 10
eth1: Identified 8139 chip type 'RTL-8139'
ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 11
PCI: setting IRQ 11 as level-triggered
ACPI: PCI Interrupt 0000:00:13.2[C] -> Link [LNK3] -> GSI 11 (level, low) ->
IRQ 11
Output of lspci -vvvn:
00:0b.0 0200: 10ec:8139 (rev 20)
Subsystem: 0e11:0056
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 64 (8000ns min, 16000ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at 9000 [size=256]
Region 1: Memory at f0018800 (32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA
PME(D0-,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: 8139too
Kernel modules: 8139cp, 8139too
Why does not udev coldpluggin first try to load 8139cp instead of
8139too?
--
Frederik Himpe <[EMAIL PROTECTED]>
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
