In case the gpio based volatage selection mode is not used for either of
buck 1/2/5, then only the BUCKxDVS1 register need to be programmed. So
determine whether dvs mode is used and limit the loop count appropriately.
Cc: MyungJoo Ham <myungjoo....@samsung.com>
Signed-off-by: Thomas Abraham <thomas.abra...@linaro.org>
---
drivers/regulator/max8997.c | 9 ++++++---
1 files changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/regulator/max8997.c b/drivers/regulator/max8997.c
index 8901371..231fcdb 100644
--- a/drivers/regulator/max8997.c
+++ b/drivers/regulator/max8997.c
@@ -941,7 +941,7 @@ static int max8997_pmic_probe(struct platform_device *pdev)
struct regulator_dev **rdev;
struct max8997_data *max8997;
struct i2c_client *i2c;
- int i, ret, size;
+ int i, ret, size, nr_dvs;
u8 max_buck1 = 0, max_buck2 = 0, max_buck5 = 0;
if (!pdata) {
@@ -973,7 +973,10 @@ static int max8997_pmic_probe(struct platform_device *pdev)
memcpy(max8997->buck125_gpios, pdata->buck125_gpios, sizeof(int) * 3);
max8997->ignore_gpiodvs_side_effect = pdata->ignore_gpiodvs_side_effect;
- for (i = 0; i < 8; i++) {
+ nr_dvs = (pdata->buck1_gpiodvs || pdata->buck2_gpiodvs ||
+ pdata->buck5_gpiodvs) ? 8 : 1;
+
+ for (i = 0; i < nr_dvs; i++) {
max8997->buck1_vol[i] = ret =
max8997_get_voltage_proper_val(
&buck1245_voltage_map_desc,
@@ -1020,7 +1023,7 @@ static int max8997_pmic_probe(struct platform_device
*pdev)
}
/* Initialize all the DVS related BUCK registers */
- for (i = 0; i < 8; i++) {
+ for (i = 0; i < nr_dvs; i++) {
max8997_update_reg(i2c, MAX8997_REG_BUCK1DVS1 + i,
max8997->buck1_vol[i],
0x3f);
--
1.6.6.rc2
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
