Vendor is below:
usb 1-8: New USB device found, idVendor=05d8, idProduct=810f
usb 1-8: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Note it does work as I said AFTER boot is complete but not if its plugged in during the
boot phase..
so i must be something to do with how USB is initialised perhaps?
Note it does work sometimes during reboot so perhaps some timing issue during
init?
thanks
Paul
On 2/12/2009 6:28 PM, ALi wrote:
Are you sure that your usb is dib0700?
if you look on the sources .... you wont see idVendor=413c,
idProduct=3010 however there is
os...@x-evian:/usr/src/linux-source-2.6.30/drivers/media/dvb/dvb-usb$
grep 05d8 * -iR
Coincidencia en el fichero binario dvb-usb-dib0700.ko
dvb-usb-dib0700.mod.c:MODULE_ALIAS("usb:v05D8p810Fd*dc*dsc*dp*ic*isc*ip*");
in the file .... so .... try to recompile it with your device id, and
pray for it :)
On Wed, Dec 2, 2009 at 5:15 AM, Paul <myli...@wilsononline.id.au> wrote:
On 2/12/2009 12:35 PM, Paul wrote:
I have a DVB-T USB device ( T14BR),
which seems to work fine when I plug in my Fedora 10 box but I if I
reboot with device connected it regularity fails to initialise correctly
and to correct I have to remove unplug-device remove the module and
reload module to fix up and only after system has been fully booted
eg
modprobe -r dvb-usb-dib0700
then
modprobe dvb-usb-dib0700 adapter_nr=2
and then plug device in.
I get the following msgs when it seems to fail and the second set when
it works
kernel log (failed)
Nov 22 13:51:50 mythbox kernel: usb 2-7: new full speed USB device using
ohci_hcd and address 2
Nov 22 13:51:50 mythbox kernel: usb 2-7: new full speed USB device using
ohci_hcd and address 3
Nov 22 13:51:50 mythbox kernel: usb 2-7: new full speed USB device using
ohci_hcd and address 4
Nov 22 13:51:50 mythbox kernel: usb 2-7: new full speed USB device using
ohci_hcd and address 5
Nov 22 13:51:50 mythbox kernel: usb 2-8: new low speed USB device using
ohci_hcd and address 6
Nov 22 13:51:50 mythbox kernel: usb 2-8: configuration #1 chosen from 1
choice
Nov 22 13:51:50 mythbox kernel: usb 2-8: New USB device found,
idVendor=413c, idProduct=3010
Nov 22 13:51:50 mythbox kernel: usb 2-8: New USB device strings: Mfr=0,
Product=0, SerialNumber=0
Nov 22 13:51:50 mythbox kernel: usbcore: registered new interface driver
hiddev
Nov 22 13:51:50 mythbox kernel: input: HID 413c:3010 as
/devices/pci0000:00/0000:00:02.0/usb2/2-8/2-8:1.0/input/input4
Nov 22 13:51:50 mythbox kernel: input,hidraw0: USB HID v1.00 Mouse [HID
413c:3010] on usb-0000:00:02.0-8
Nov 22 13:51:50 mythbox kernel: usbcore: registered new interface driver
usbhid
Nov 22 13:51:50 mythbox kernel: usbhid: v2.6:USB HID core driver
http://www.artectv.com/ehtm/products/t14.htm
kernel log (working)
Nov 29 09:58:20 mythbox kernel: usb 1-8: new high speed USB device using
ehci_hcd and address 3
Nov 29 09:58:20 mythbox kernel: usb 1-8: configuration #1 chosen from 1
choice
Nov 29 09:58:20 mythbox kernel: usb 1-8: New USB device found,
idVendor=05d8, idProduct=810f
Nov 29 09:58:20 mythbox kernel: usb 1-8: New USB device strings: Mfr=1,
Product=2, SerialNumber=3
Nov 29 09:58:20 mythbox kernel: usb 1-8: Product: ART7070
Nov 29 09:58:20 mythbox kernel: usb 1-8: Manufacturer: Ultima
Nov 29 09:58:20 mythbox kernel: usb 1-8: SerialNumber: 001
Nov 29 09:58:20 mythbox kernel: dib0700: loaded with support for 7
different device-types
Nov 29 09:58:20 mythbox kernel: dvb-usb: found a 'Artec T14BR DVB-T' in
cold state, will try to load a firmware
Nov 29 09:58:20 mythbox kernel: firmware: requesting
dvb-usb-dib0700-1.10.fw
Nov 29 09:58:20 mythbox kernel: dvb-usb: downloading firmware from file
'dvb-usb-dib0700-1.10.fw'
Nov 29 09:58:22 mythbox kernel: dib0700: firmware started successfully.
Nov 29 09:58:23 mythbox kernel: dvb-usb: found a 'Artec T14BR DVB-T' in
warm state.
Nov 29 09:58:23 mythbox kernel: dvb-usb: will pass the complete MPEG2
transport stream to the software demuxer.
Nov 29 09:58:23 mythbox kernel: DVB: registering new adapter (Artec
T14BR DVB-T)
Nov 29 09:58:23 mythbox kernel: DiB0070: successfully identified
Nov 29 09:58:23 mythbox kernel: input: IR-receiver inside an USB DVB
receiver as /devices/pci0000:00/0000:00:02.1/usb1/1
-8/input/input7
Nov 29 09:58:23 mythbox kernel: dvb-usb: schedule remote query interval
to 150 msecs.
Nov 29 09:58:23 mythbox kernel: dvb-usb: Artec T14BR DVB-T successfully
initialized and connected.
Note I googled a few other people with the same issue:
http://www.linuxtv.org/pipermail/linux-dvb/2007-November/022145.html
http://ubuntuforums.org/archive/index.php/t-1233131.html
so I'm assuming its a known issue, right?
Paul
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
