On Wed, Apr 07, 2010 at 06:20:07AM -0400, Andy Walls wrote: > On Tue, 2010-04-06 at 11:26 -0300, Mauro Carvalho Chehab wrote: > > I won't comment every single bits of the change, since we're more > > interested on the conceptual > > aspects. > > > > > -int ir_raw_event_store(struct input_dev *input_dev, enum raw_event_type > > > type) > > > > Don't remove the raw_event_store. It is needed by the hardware that gets > > events from > > IRQ/polling. For sure another interface is needed, for the cases where the > > hardware pass their > > own time measure, like cx18 > > (http://linuxtv.org/hg/~awalls/cx23885-ir2/rev/2cfef53b95a2). > > > > For those, we need something like: > > > > int ir_raw_event_time_store(struct input_dev *input_dev, enum > > raw_event_type type, u32 nsecs) > > > > Where, instead of using ktime_get_ts(), it will use the timing provided by > > the hardware. > > Just to clarify what Conexant hardware, and my current driver for it, is > capable of: > > 1. It provides raw pulse (and space) width measurements. > > 2. Those measurements can have very high resoltuion (~37 ns IIRC) or > very low resolution (usec or msec IIRC) depending on how the hardware > clock dividers are set up. > > 3. The hardware provides a timeout when the measurment timer overflows, > meaning that no edge happened for a very long time. This generates a > special "overflow" measurment value and a receiver timeout interrupt. > > 4. The hardware has an 8 measurement deep FIFO, which the driver starts > to drain whenever it is half full (i.e. pulse measurement data is > delayed). This happens in response to a hardware FIFO service request > interrupt. > > 5. The hardware FIFO is drained by the driver whenever an interrupt is > received and the available measruement data is placed into a kfifo(). > This will then signal a work handler that it has work to do. > > 6. Measurements are scaled to standard time units (i.e. ns) by the > driver when they are read out of the kfifo() by a work handler. (No > sense in doing time conversions in an interrupt handler). > > 7. The work handler then begins passing whatever measurements it has, > one at a time, over to a pulse stream decoder. > > 8. If the pulse stream decoder actually decodes something, it is passed > over to the input subsystem. > > I suspect this device's behavior is much closer to what the MCE-USB > device does, than the raw GPIO handlers, but I don't really know the > MCE-USB.
This sounds very similar to winbond-cir (the hardware parts that is, basically until and including item 5, line 1). The mceusb HW does something similar...it sends usb packets with a couple of pulse/space duration measurements (of 50us resolution IIRC)...and it automatically enters an inactive state after 10000 us of silence. The ir_raw_event_duration() function of my patch is intended for exactly this kind of hardware (which I mentioned in my reply to Mauro which I just sent out). The question is though, is the kfifo and work handler really necessary? -- David Härdeman -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
