Hi Ulf Hansson, Thanks for your comments. Such retry mechanism is a simple CMD-level or sdio-core-level retry which takes advantage of the mmc core internal retry. There is not any side effect, but with it, even those SDIO function driver's without its own retrying mechanism can benefit in some conditions.
Besides, for CMD52, it can be used during SDIO card initialization/detection phase. At that time, SDIO function driver hasn't started to work. Of course we can probably encounter CMD52 error due to some reasons(eg, board-level schematic bad behavior), and such retry can be a potential workaround. Actually, we've encountered exactly such case in our development. Best Wishes, Yong Ding Operating Systems Engineering, Application Processor Systems Engineering -----Original Message----- From: Ulf Hansson [mailto:[email protected]] Sent: Monday, May 14, 2012 8:58 PM To: Yong Ding Cc: [email protected]; [email protected]; [email protected]; [email protected]; [email protected]; [email protected] Subject: Re: [PATCH] mmc:sdio:retry CMD52/53 when error happens Hi Yongd, From my perspective I don't think this patch is wanted. A retry mechanism is likely very much hw-SDIO device dependent. Upper layers (SDIO func driver) is thus the only software that is able to handle retries correctly. Kind regards Ulf Hansson On 05/14/2012 10:39 AM, yongd wrote: > Set sdio CMD52/53's retry time as MMC_CMD_RETRIES. As a result, > sdio might benefit from core-internal CMD retry mechanism when > some errors happen(CRC, etc). > > Signed-off-by: yongd<[email protected]> > --- > drivers/mmc/core/sdio_ops.c | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/drivers/mmc/core/sdio_ops.c b/drivers/mmc/core/sdio_ops.c > index d29e206..884c27e 100644 > --- a/drivers/mmc/core/sdio_ops.c > +++ b/drivers/mmc/core/sdio_ops.c > @@ -86,7 +86,7 @@ static int mmc_io_rw_direct_host(struct mmc_host *host, int > write, unsigned fn, > cmd.arg |= in; > cmd.flags = MMC_RSP_SPI_R5 | MMC_RSP_R5 | MMC_CMD_AC; > > - err = mmc_wait_for_cmd(host,&cmd, 0); > + err = mmc_wait_for_cmd(host,&cmd, MMC_CMD_RETRIES); > if (err) > return err; > > @@ -147,6 +147,7 @@ int mmc_io_rw_extended(struct mmc_card *card, int write, > unsigned fn, > else > cmd.arg |= 0x08000000 | blocks; /* block mode */ > cmd.flags = MMC_RSP_SPI_R5 | MMC_RSP_R5 | MMC_CMD_ADTC; > + cmd.retries = MMC_CMD_RETRIES; > > data.blksz = blksz; > /* Code in host drivers/fwk assumes that "blocks" always is>=1 */ -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
