Hi,
  I'll start by saying this problem has eluded me for weeks now and I hope 
some one out there can make a suggestion as to where to start.

  I have tried the last 3 versions of the kernel (125,126,127 and all the 
patches I can find) and they compile and run great.  Currently running
2.0.34 (when I need ppp) and 2.1.127 w/ ac1.  Also have a 3Com 905B-TX and 
have used the 99.E drivers... It works somewhat, I can ping everything on the 
local network.  But... I get lo errors and ppp says routing is broke.  Here 
is some output:

--output from netstat -rn
-------------------------------------------
Kernel IP routing table
Destination     Gateway         Genmask         Flags   MSS Window  irtt Iface
205.199.206.224 205.199.206.230 255.255.255.240 UG  0 0      0 eth0
205.199.206.224 0.0.0.0         255.255.255.240       U     0 0     0 eth0
205.199.206.224 0.0.0.0         255.255.255.240       U     0 0     0 eth0
*** actually has two entries in the table. dunno why !!!!!***
127.0.0.0           0.0.0.0         255.0.0.0                  U     0 0  0 lo
0.0.0.0          205.199.206.230 0.0.0.0         UG        0 0          0 eth0

--output from ifconfig -a
-------------------------------------------
lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Bcast:127.255.255.255  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:3924  Metric:1
          RX packets:3814 errors:0 dropped:0 overruns:0
          TX packets:0 errors:623736 dropped:3814 overruns:0
*** lots of errors ****

eth0      Link encap:Ethernet  HWaddr 00:10:5A:27:73:AE
          inet addr:205.199.206.230  Bcast:205.199.206.230
                                  Mask:255.255.255.240
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:5 errors:0 dropped:0 overruns:0
          TX packets:0 errors:0 dropped:179 overruns:0
          Interrupt:19 Base address:0xb800 

--output from tail /var/log/messages
-------------------------------------------
Nov  9 21:07:56 goliath pppd[679]: pppd 2.3.3 started by root, uid 0
Nov  9 21:07:56 goliath pppd[679]: Using interface ppp0
Nov  9 21:07:56 goliath pppd[679]: Connect: ppp0 <--> /dev/ttyS1
Nov  9 21:07:58 goliath pppd[679]: Remote message: 
Nov  9 21:07:58 goliath pppd[679]: ioctl(SIOCADDRT) device route: Network is 
down(100)
Nov  9 21:07:59 goliath pppd[679]: Connection terminated.
Nov  9 21:07:59 goliath pppd[679]: Hangup (SIGHUP)
Nov  9 21:08:11 goliath pppd[679]: Terminating on signal 15.
Nov  9 21:08:12 goliath pppd[679]: Exit.
Nov  9 21:09:32 goliath kernel: PPP: ppp line discipline successfully 
unregistered
-----------------------------------------

I have created /dev/route with the proper maj/min nodes.  Not sure what else 
I need to do at this point.  I have used the latest modutils also.  Had to 
reinstall 2.1.85 to get 2.0.34 to work again.  I've only been at this about a 
year now...This may be third grade stuff to some, but for us kindergardner's 
it's tough.  Oh well, I came for an education :) 


-------------------------------------
Dave Helton       [EMAIL PROTECTED]

-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]

Reply via email to