-----Original Message-----
From: Corrigan, Brian <[EMAIL PROTECTED]>
To: 'michael jones' <[EMAIL PROTECTED]>
Date: Wednesday, August 05, 1998 8:16 AM
Subject: RE: What motherboard to buy for AMDK233??
>NO UMA Unified Memory Architecture, it means it sharess video and system
>ram.. Kindo of a shitty system, but it makes for a cheap system
i didn't know what it was called. that is the same setup for the Cyrix
MediaGX systems. If you have 24Meg Ram installed, you only get
22 cause the onboard video uses system ram. i acquired one
somewhere, what a mess! i gave it away to my brother-in-law for his
kids. not good for much else.
>
>Brian Corrigan
>Personal- [EMAIL PROTECTED]
>Network Support- [EMAIL PROTECTED]
>ICQ- 467162
>
>>-----Original Message-----
>>From: michael jones [SMTP:[EMAIL PROTECTED]]
>>Sent: Tuesday, August 04, 1998 4:19 PM
>>To: James Maddison
>>Cc: Corrigan, Brian; 'Linux Newbie List'
>>Subject: Re: What motherboard to buy for AMDK233??
>>
>>
>>
>>James Maddison wrote:
>>
>>> Brian,
>>>
>>> What motherboard you choose depends on what you're planning on doing
>>> with your computer. If you're doing lots of graphics work you'll find
>>> 64mb of RAM to be pretty slim. And the Intel TX chipsets are limited to
>>> being able to effectively cache only 64mb of RAM.
>>>
>>> Personally, I don't think the motherboard is the area to cut a corner on
>>> a new system. It is the basis of the system. Buy something that's
>>> gonna be flexible and expandable. Soyo make a nice quality Super 7
>>> motherboard (the SY-5EH, based on VIA's MVP3 chipset, has 1 mb of L2
>>> cache, 4 PCI, 2 ISA, and 1 AGP slots, 2 SIMM and 2 DIMM slots) that will
>>> cache more than 64mb of RAM and you should be able to pick it up for
>>> less than $100.00. And it's easy to setup and has good documentation.
>>
>>the FIC VA-503+ is a nice board for super socket 7. make sure you
getPC-100
>>quality ram if your going to run 100mhz bus.
>>
>>>
>>>
>>> If you want something that's proven, stable, and somewhat exapandable
>>> and you're on a budget then I'd recommend the Abit TX5. Nice board.
>>> Setting up your CPU will be a snap as well because it's a jumperless
>>> board. Just make sure you get revision 1.2
>>
>>its marked on the last isa slot.
>>
>>> so that it has the 2.2v
>>> jumper on board which will enable it to support the new AMD chips (K6
>>> 266 and 300's). You should be able to pick this board up for about
>>> $65.00 now. And you should be able to get 64mb of SDRAM for it for
>>> about the same price as the board ($65.00).
>>
>>i am using this board and have had nothing but pleasant experiences. i run
>>aAMD K6-233, no overclocking. i have a friend who runs his with a
>>AMD K6-266 clocked to 300 with absolute stability so far.
>>
>>>
>>
>>> Also you didn't mention whether you need an AT or ATX form factor
>>
>>the Abit will run on AT or ATX power. there are cases available that
haveATX
>>power with the ability to fit AT boards. mine has plates that will fit
>>different forms. so you have that flexibility.
>>
>>> board. If you're using an existing case from an old system, then more
>>> than likely it's AT form. ATX is the "newer" form factor though it's
>>> been out for awhile. It might not be a bad idea to get a board that can
>>> handle the ATX power supply and an ATX case. In the future most boards
>>> will probably be ATX form.
>>>
>>> Hope this helps a little,
>>>
>>> James
>>>
>>> Corrigan, Brian wrote:
>>> >
>>> > I am building an AMD k6233 computer. I want 64mb of ram and 4.3 gig
>>> > disk. as well as at least a 2mb video card. I have a question as to
>>> > what motherboard to buy.
>>> > I am looking at one that has a 512k cache the TX chipset and
accomodates
>>> > the amd chip and costs 82.00. On top of that I am buying an s3Virge
>>> > Based Video Card with 2 mb of ram for $32.00
>>
>>a matrox mystique has 4 megs, is supported by linux, and can be had for
$60.
>>
>>> > I was looking around today and saw the Amptron 9100 Super TX3. This
MB
>>> > one has on board video and sound card. It uses UMA.
>>
>>UDMA? is you drive a UDMA drive?
>>
>>> It costs only
>>> > $60.00 (And the video is built in!) Has anyone used this MB in linux?
>>> > Based on my desired system, can anyone reccommend a motherboard to me?
>>> > Thanks alot for all the help...
>>
>>a general rule, beware boards with built in sound & video.
>>
>>> >
>>> > Brian Corrigan
>>> > Personal- [EMAIL PROTECTED]
>>> > Network Support- [EMAIL PROTECTED]
>>> > ICQ- 467162
>>
>>
>>
>>--
>>michael jones * erleichda archiving * harleysville, pa usa
>>http://www.voicenet.com/~blindman
>>
>>
>
