Micah --
I don't know about the PnP stuff, so I'm assuming you've got that part right
and you have a working, real (non-HSP) modem where you say it is. In that
case ...
You do want to configure a /dev/ttyS* port to that ITQ/IO Port combo -- it
combines the (default) IRQ for S2 with the IO of S3. So one thing to do is:
setserial /dev/ttyS3 irq 4
Then probe to see if setserial can find a UART type; enter
setserial /dev/ttyS3
and see if the response includes a UART type. If it did, your modem is
found. If not, you still don't have a working modem.
make sure that /dev/modem is a symlink to /dev/ttyS3
At 12:10 AM 2/16/99 -0500, you wrote:
> OK, I got some things to work. I ran pnpdump --config >
>/etc/isapnp.conf and it says every thing is ok. My sound card works,
>after I ran soundconfig. But, I can not get my modem to work. Isapnp
>says that my modem is set for 0x100 2e8 on irq 4. Do I need to
>configure one of my ttyS* so I it will work? If so, then how? When I
>try to use the modem config tool in the control panel, then try to run
>kppp it says my modem is busy.
------------------------------------"Never tell me the odds!"---
Ray Olszewski -- Han Solo
762 Garland Drive
Palo Alto, CA 94303-3603
650.321.3561 voice 650.322.1209 fax [EMAIL PROTECTED]
----------------------------------------------------------------
