On Tue, 23 Nov 1999, Ricardo Denis wrote:
>hello all,
>
>i issue the following comands :
>
>slattach -p slip -s 38400 /dev/ptypf &
>sleep 3
>ifconfig sl0 pointopoint 44.163.68.11 mtu 1536 44.163.68.20
>sleep 3
>route add 44.163.68.11 sl0
>sleep 3
>route add -net 44.0.0.0 netmask 255.0.0.0 gw 44.163.68.11
>sleep 3
>
>then i issue :
>
>ifconfig sl0
>
>and i get :
>
>sl0 Link encap:Serial Line IP
> inet addr:44.163.68.20 P-t-P:44.163.68.20 Mask:255.255.255.255
> UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1536 Metric:1
> RX packets:132 errors:0 dropped:0 overruns:0 frame:0
> TX packets:90 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:10
>
>notice it has the same ip address for both ends of the point to point link
>and that is *not* what was specified in the ifconfig command. what did i
>miss here? thanks for any help.
>
That happens here also, i think its because you are defineing the
othersides IP "before" the program has been started, the program
possably being Jnos or Tnos right.?
O yes, the need for sleep(s) is not absolultely nessacary.
If you consult the nos-bbs archive at hyrda@carleton you might well
find a beter answer as i belive this has been dissussed on the
nos-bbs list before.
>rick
--
Regards Richard
[EMAIL PROTECTED]
http://people.zeelandnet.nl/pa3gcu/
