> The Advansys driver /proc output indicates 4 SCSI bus resets were received. So the >SCSI bus is probably hanging, commands are > timing out, and the mid-layer is sending the Advansys driver reset commands. This would explain that both my drives don't respond anymore after a access to the cdwriter. It was I meant by "scsi chain out of order". > If you're using only one connector on the adapter (and one cable) only the last >drive should be terminated. The adapter will > terminate its end. Also can you use the CD writer without the hangs if you remove >the Plextor drive? I didn't have time yesterday to check in the hardware in my box, will do it. 1. cable and termination 2. W/ and W/O Plextor mounting the device? Also I don't know why your listing > says you have a 2.2.13 kernel but you have the Advansys 3.1E driver. The official >2.2.13 kernel has the Advansys 3.2F driver. If > you don't know why yours is different maybe you should get the original kernel >source and build a new kernel from scratch to see if > the behavior changes. I got the sources of 2.2.14 but got some troubles while compiling the modules. I have to clarify the problem before going further in the scsi issue. I think my software issues don't meet the requested update (Procps for example), and the modules are not installed. First I'm going to see if a new and working kernel makes the law, else I will ask for your help once again. THX Charlie - To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to [EMAIL PROTECTED] Please read the FAQ at http://www.linux-learn.org/faqs
