I have two 10 GB harddisks, and I am trying to install lilo to the
second one. The boot partition is the first partition, and it is 40 MB,
so this should satisfy the 1024 cylinder requirement. I first tried
booting after a Redhat 6.1 install, it stopped at LI. Then, after
reading some LILO docs, I tried the 'linear' option, with the same
response. Then I tried to enter the disk geometry as seen on bios setup
(sec=63, head=255, cyl=1216). It still stops at LI. I really don't want
to use LOADLIN. Any ideas?
Thanks.
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.linux-learn.org/faqs
