i see the following lines in the omap-osk.c file regarding the uarts:
static struct omap_uart_config osk_uart_config __initdata = {
.enabled_uarts = (1 << 0),
};
what does it mean? i want all my uarts (1,2,3) enabled. how do i have
to modify the above line?
thanx for the help.
regards,
Shareef
On Wed, May 21, 2008 at 9:10 PM, Tony Lindgren <[EMAIL PROTECTED]> wrote:
> * mohammed shareef <[EMAIL PROTECTED]> [080520 23:43]:
>> Hello,
>>
>> How do i enable UART2 on omap5912_osk in the kernel?
>>
>> and is there a way by which i can test if the uart2 has been recongnised?
>>
>> i dont see uart module being initialized during the kernel boot-up.
>
> You need to enable it in board-osk.c, see enabled_uarts. Then to use it
> you also need the right hardware attached to it.
>
> Tony
>
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
