On ti, 2008-08-05 at 13:50 +0300, ext Tony Lindgren wrote:
> * Peter 'p2' De Schrijver <[EMAIL PROTECTED]> [080721 19:03]:
> > 
> > Signed-off-by: Peter 'p2' De Schrijver <[EMAIL PROTECTED]>
> > ---
> >  arch/arm/mach-omap2/smartreflex.c |   10 +++++-----
> >  1 files changed, 5 insertions(+), 5 deletions(-)
> > 
> > diff --git a/arch/arm/mach-omap2/smartreflex.c 
> > b/arch/arm/mach-omap2/smartreflex.c
> > index 0f3a659..b41fe96 100644
> > --- a/arch/arm/mach-omap2/smartreflex.c
> > +++ b/arch/arm/mach-omap2/smartreflex.c
> > @@ -396,17 +396,17 @@ static void sr_configure_vc(void)
> >  
> >     /* Setup voltctrl and other setup times */
> >     /* XXX CONFIG_SYSOFFMODE has not been implemented yet */
> > -#ifdef CONFIG_SYSOFFMODE
> > -   prm_write_mod_reg(OMAP3430_AUTO_OFF | OMAP3430_AUTO_RET,
> > -                   OMAP3430_GR_MOD,
> > +#ifdef CONFIG_OMAP_SYSOFFMODE
> > +   prm_write_mod_reg(OMAP3430_AUTO_OFF | OMAP3430_AUTO_RET |
> > +                   OMAP3430_SEL_OFF, OMAP3430_GR_MOD,
> >                     OMAP3_PRM_VOLTCTRL_OFFSET);
> >  
> >     prm_write_mod_reg(OMAP3430_CLKSETUP_DURATION, OMAP3430_GR_MOD,
> >                     OMAP3_PRM_CLKSETUP_OFFSET);
> >     prm_write_mod_reg((OMAP3430_VOLTSETUP_TIME2 <<
> > -                   OMAP3430_VOLTSETUP_TIME2_OFFSET) |
> > +                   OMAP3430_SETUP_TIME2_SHIFT) |
> >                     (OMAP3430_VOLTSETUP_TIME1 <<
> > -                   OMAP3430_VOLTSETUP_TIME1_OFFSET),
> > +                   OMAP3430_SETUP_TIME1_SHIFT),
> >                     OMAP3430_GR_MOD, OMAP3_PRM_VOLTSETUP1_OFFSET);
> >  
> >     prm_write_mod_reg(OMAP3430_VOLTOFFSET_DURATION, OMAP3430_GR_MOD,
> 
> Do we need the CONFIG_SYSOFFMODE option? How about just add
> /sys/power/off_while_idle and if that's set to 1 then allow off mode?

I would say no, we don't need the CONFIG_SYSOFFMODE option.

I think we can always use 0 volt sys off mode for suspend, since it's
user activated and the wake-up latency is still in range of only few ms.

Dynamic idle is bit different, because the system would have to be idle
a lot longer for the 0V off mode to pay off (when comparing to sleep
voltage off mode). We could have an extra C-state in the upcoming
cpu-idle driver for 0 volt off-mode. Richard, Rajendra, any thoughts?

If that's not feasible, the "off_while_idle" sysfs interface can be
created. 

Br,
Kalle


> 
> Tony
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to [EMAIL PROTECTED]
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to