* David Brownell <[EMAIL PROTECTED]> [081105 23:10]:
> On Wednesday 05 November 2008, Tony Lindgren wrote:
> > OK, I've pushed the hsmmc init patches. They still need work though.
> >
> > Please everybody check your board MMC configuration and send patches
> > as needed.
>
> See the appended build fixes ... :)
Oops, sorry I did not expect that kind of fixes!
> Also, I suspect there needs to be an MMC_CAP_8_BIT_DATA at
> some point, with hsmmc driver support.
>
>
> > Also the write protect interrupts are not handled, and gpio handling
> > is twl specific. Hopefully a better base for the code anyways.
>
> I'll have a look at write protect ... it wouldn't normally
> be an IRQ, just an input GPIO. Unlike the CD, which gets
> used for both purposes; that code looks iffy too.
OK. We also need to figure out what to do if we need to support other
gpios than twl gpios.
> Yes, a better base.
Thanks, pushing.
Tony
>
> - Dave
>
>
> ========= CUT HERE
> From: David Brownell <[EMAIL PROTECTED]>
>
> Build fixes for "HSMMC: Improve the interface for hsmmc_init()".
> The header file needs to work without MMC support enabled, and
> some board files needed to include it.
>
> Signed-off-by: David Brownell <[EMAIL PROTECTED]>
> ---
> arch/arm/mach-omap2/board-2430sdp.c | 3 +++
> arch/arm/mach-omap2/board-ldp.c | 3 +++
> arch/arm/mach-omap2/board-omap2evm.c | 3 +++
> arch/arm/mach-omap2/board-omap3beagle.c | 2 ++
> arch/arm/mach-omap2/board-omap3evm.c | 2 ++
> arch/arm/mach-omap2/board-omap3pandora.c | 2 ++
> arch/arm/mach-omap2/mmc-twl4030.h | 8 ++++----
> 7 files changed, 19 insertions(+), 4 deletions(-)
>
> --- a/arch/arm/mach-omap2/board-2430sdp.c
> +++ b/arch/arm/mach-omap2/board-2430sdp.c
> @@ -44,6 +44,9 @@
>
> #include <asm/io.h>
>
> +#include "mmc-twl4030.h"
> +
> +
> #define SDP2430_FLASH_CS 0
> #define SDP2430_SMC91X_CS 5
>
> --- a/arch/arm/mach-omap2/board-ldp.c
> +++ b/arch/arm/mach-omap2/board-ldp.c
> @@ -41,6 +41,9 @@
> #include <asm/delay.h>
> #include <mach/control.h>
>
> +#include "mmc-twl4030.h"
> +
> +
> #define CONFIG_DISABLE_HFCLK 1
>
> #define ENABLE_VAUX1_DEDICATED 0x03
> --- a/arch/arm/mach-omap2/board-omap2evm.c
> +++ b/arch/arm/mach-omap2/board-omap2evm.c
> @@ -41,6 +41,9 @@
> #include <mach/mcspi.h>
> #include <mach/mux.h>
>
> +#include "mmc-twl4030.h"
> +
> +
> #define GPMC_OFF_CONFIG1_0 0x60
>
> static struct mtd_partition omap2evm_nand_partitions[] = {
> --- a/arch/arm/mach-omap2/board-omap3beagle.c
> +++ b/arch/arm/mach-omap2/board-omap3beagle.c
> @@ -44,6 +44,8 @@
> #include <mach/mux.h>
>
> #include "twl4030-generic-scripts.h"
> +#include "mmc-twl4030.h"
> +
>
> #define GPMC_CS0_BASE 0x60
> #define GPMC_CS_SIZE 0x30
> --- a/arch/arm/mach-omap2/board-omap3evm.c
> +++ b/arch/arm/mach-omap2/board-omap3evm.c
> @@ -40,6 +40,8 @@
>
> #include "sdram-micron-mt46h32m32lf-6.h"
> #include "twl4030-generic-scripts.h"
> +#include "mmc-twl4030.h"
> +
>
> static struct resource omap3evm_smc911x_resources[] = {
> [0] = {
> --- a/arch/arm/mach-omap2/board-omap3pandora.c
> +++ b/arch/arm/mach-omap2/board-omap3pandora.c
> @@ -47,6 +47,8 @@
> #include <mach/usb-musb.h>
>
> #include "sdram-micron-mt46h32m32lf-6.h"
> +#include "mmc-twl4030.h"
> +
>
> #define NAND_BLOCK_SIZE SZ_128K
> #define GPMC_CS0_BASE 0x60
> --- a/arch/arm/mach-omap2/mmc-twl4030.h
> +++ b/arch/arm/mach-omap2/mmc-twl4030.h
> @@ -6,20 +6,20 @@
> * published by the Free Software Foundation.
> */
>
> -#if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE) || \
> - defined(CONFIG_MMC_OMAP_HS) || defined(CONFIG_MMC_OMAP_HS_MODULE)
> -
> struct twl4030_hsmmc_info {
> u8 mmc; /* controller 1/2/3 */
> u8 wires; /* 1/4/8 wires */
> int gpio_cd; /* or -EINVAL */
> };
>
> +#if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE) || \
> + defined(CONFIG_MMC_OMAP_HS) || defined(CONFIG_MMC_OMAP_HS_MODULE)
> +
> void hsmmc_init(struct twl4030_hsmmc_info *);
>
> #else
>
> -static inline void hsmmc_init(struct twl4030_hsmmc_info *)
> +static inline void hsmmc_init(struct twl4030_hsmmc_info *info)
> {
> }
>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
