On Fri, Dec 19, 2008 at 12:25:16PM +0200, ext Tomi Valkeinen wrote:
> Yesterday's "Merge branch 'musb'" broke the USB slightly on our board. I
> use NFS root via USB gadget ethernet and if I have the usb cable
> connected when the device boots up, the network does not go up
> correctly. If I disconnect and connect the cable the USB starts working.
>
> I can't currently test this on other boards, but I will test it on
> beagle later.
>
> g_ether gadget: high speed config #1: CDC Ethernet (ECM)
> IP-Config: Guessing netmask 255.255.255.0
> IP-Config: Complete:
> device=usb0, addr=192.168.2.15, mask=255.255.255.0, gw=255.255.255.255,
> host=192.168.2.15, domain=, nis-domain=(none),
> bootserver=255.255.255.255, rootserver=192.168.2.14, rootpath=
> Looking up port of RPC 100003/2 on 192.168.2.14
>
> (at this point the interface is up on PC side, but pings don't go through)
Could you try this patch: (untested)
diff --git a/drivers/usb/musb/musb_gadget.c b/drivers/usb/musb/musb_gadget.c
index 3e56582..9512816 100644
--- a/drivers/usb/musb/musb_gadget.c
+++ b/drivers/usb/musb/musb_gadget.c
@@ -106,7 +106,6 @@ __acquires(ep->musb->lock)
{
struct musb_request *req;
struct musb *musb;
- int busy = ep->busy;
req = to_musb_request(request);
@@ -115,7 +114,6 @@ __acquires(ep->musb->lock)
req->request.status = status;
musb = req->musb;
- ep->busy = 1;
spin_unlock(&musb->lock);
if (is_dma_capable()) {
if (req->mapped) {
@@ -144,9 +142,9 @@ __acquires(ep->musb->lock)
ep->end_point.name, request,
req->request.actual, req->request.length,
request->status);
+ ep->busy = 0;
req->request.complete(&req->ep->end_point, &req->request);
spin_lock(&musb->lock);
- ep->busy = busy;
}
/* ----------------------------------------------------------------------- */
@@ -290,7 +288,7 @@ static void txstate(struct musb *musb, struct musb_request
*req)
csr);
#ifndef CONFIG_MUSB_PIO_ONLY
- if (is_dma_capable() && musb_ep->dma) {
+ if (fifo_count > musb_ep->packet_sz && is_dma_capable() &&
musb_ep->dma) {
struct dma_controller *c = musb->dma_controller;
use_dma = (request->dma != DMA_ADDR_INVALID);
@@ -1077,10 +1075,13 @@ static void musb_ep_restart(struct musb *musb, struct
musb_request *req)
&req->request, req->request.length, req->epnum);
musb_ep_select(musb->mregs, req->epnum);
- if (req->tx)
+ if (req->tx) {
+ musb->endpoints[req->epnum].ep_in.busy = 1;
txstate(musb, req);
- else
+ } else {
+ musb->endpoints[req->epnum].ep_out.busy = 1;
rxstate(musb, req);
+ }
}
static int musb_gadget_queue(struct usb_ep *ep, struct usb_request *req,
--
balbi
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
