On 02/05/14 14:25, Javier Martinez Canillas wrote: > Hello Koen, > > On Fri, May 2, 2014 at 12:47 PM, Koen Kooi <[email protected]> wrote: >> Hi, >> >> I've been trying to get DVI on my beagleboard XM to output a picture with >> mainline and with 3.15rc it still doesn't work. If I statically build in >> everything the drm encoders and connectors all go into deferred probe mode >> and fail, falling back to 1024x768. I with omapdrm and encoders/outputs/etc >> as modules deferred probe is avoided, far fewer error messages and a >> 1280x1024 resolution is being used. But still the monitor still says 'no >> signal' detected. >> >> So what's the magic to get an actual signal on the hdmi connector? >> >> regards, >> >> Koen-- > > This is a known issue as far as I know. You need [0] to correctly set > the display PLL clock rates. > > Best regards, > Javier > > [0]: http://permalink.gmane.org/gmane.linux.ports.arm.kernel/295077
Different board, different problem. The link talks about beaglebone, Koen about beagleboard. Tomi
signature.asc
Description: OpenPGP digital signature
