Op 2 mei 2014, om 13:59 heeft Tomi Valkeinen <[email protected]> het volgende geschreven:
> On 02/05/14 13:47, Koen Kooi wrote: >> Hi, >> >> I've been trying to get DVI on my beagleboard XM to output a picture with >> mainline and with 3.15rc it still doesn't work. If I statically build in >> everything the drm encoders and connectors all go into deferred probe mode >> and fail, falling back to 1024x768. I with omapdrm and encoders/outputs/etc >> as modules deferred probe is avoided, far fewer error messages and a >> 1280x1024 resolution is being used. But still the monitor still says 'no >> signal' detected. >> >> So what's the magic to get an actual signal on the hdmi connector? > > Sigh, looks like my beagle xM died on me while testing this... > > The reason for this is that the twl_gpio (which TFP410 uses) gets > initialized really late, so display things get deferred. Then, before > TFP410 has initialized, omapdrm starts. It finds VENC (tv-out) display > available, so it starts. After that TFP410 gets probed, but as DRM > doesn't support adding displays later, it is never actually added to > omapdrm. > > Also, the VENC output doesn't even work by default if > CONFIG_DRM_OMAP_NUM_CRTCS is 1. It needs to be set to 2 to support the > second output (tv-out in this case). But my board died before I managed > to test this. > > So, the probing is quite broken. And I have no good ideas how to fix it, > only bad ones... > > A simple thing to do for testing is to either disable > CONFIG_OMAP2_DSS_VENC from the kernel, or remove the svideo-connector > from the board's .dts file. This results in tv-out not being available, > so when omapdrm starts and finds no displays, it'll defer its probe, > thus getting the DVI next time it probes. I disabled CONFIG_OMAP2_DSS_VENC and DVI works as expected with everything builtin! regards, Koen-- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
