On 06/05/14 19:10, Tony Lindgren wrote: > * Darren Etheridge <[email protected]> [140422 13:39]: >> Add the necessary nodes to enable the LCD controller and the >> LCD panel that is attached to the Texas Instruments AM335x >> EVMSK platform. Also setup the necessary pin mux within the >> DT file to drive the LCD connector and add the correct >> pinmux settings for the lcd pins to be configured to when >> the SoC goes into sleep state for the minimum power >> consumption. >> >> For the sleep mode LCD pin settings, MUX_MODE7 is chosen as >> this corresponds to switching the pins into input GPIO's with >> an internal pulldown. Which has been determined to offer the >> lowest power solution vs leaving the pins configured in LCD >> mode. > > Probably best that Tomi queues all the panel .dts changes into > a separate immutable branch that I can merge too.
This is not for OMAP DSS, but for the LCDC used in beaglebone, so there are no dependencies to any of my work. Tomi
signature.asc
Description: OpenPGP digital signature
