Tomi Valkeinen <[email protected]> wrote on Fri [2014-May-09 14:29:02 +0300]: > On 06/05/14 19:10, Tony Lindgren wrote: > > * Darren Etheridge <[email protected]> [140422 13:39]: > >> Add the necessary nodes to enable the LCD controller and the > >> LCD panel that is attached to the Texas Instruments AM335x > >> EVMSK platform. Also setup the necessary pin mux within the > >> DT file to drive the LCD connector and add the correct > >> pinmux settings for the lcd pins to be configured to when > >> the SoC goes into sleep state for the minimum power > >> consumption. > >> > >> For the sleep mode LCD pin settings, MUX_MODE7 is chosen as > >> this corresponds to switching the pins into input GPIO's with > >> an internal pulldown. Which has been determined to offer the > >> lowest power solution vs leaving the pins configured in LCD > >> mode. > > > > Probably best that Tomi queues all the panel .dts changes into > > a separate immutable branch that I can merge too. > > This is not for OMAP DSS, but for the LCDC used in beaglebone, so there > are no dependencies to any of my work. >
Benoit had always queued these LCDC dts patches in the past. This is exactly the same as what had been done for AM335x-EVM and AM335x-BeagleBone both of which are already in the mainline kernel. I had just missed the EVMSK previously. Darren -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
