Each GPMC chip-select needs to be configured for (base-address,CS-size) so that
GPMC understands the address-space allocated to device connected externally.
These chip-select configurations (base-address, CS-size) follow some basic
mapping rules like:
- The CS size is programmable from 256 MBytes to 16 MBytes (must be a power of 
2)
  and is defined by the mask field. Attached memory smaller than the programmed
  CS region size is accessed through the entire CS region (aliasing).
- The programmed 'base-address' must be aligned to the 'CS-size' boundary and
  be a power of 2.
- Valid CS-size values are {256MB(max), 128MB, 64MB, 32MB and 16MB (min)}
  Any intermediate values creates holes in the chip-select memory-map.

This patch adds above checks in gpmc_cs_remap() so that any invalid value
passed by DT <reg> property can be filtered before actually allocating the
address space.

Signed-off-by: Pekon Gupta <[email protected]>
---
 arch/arm/mach-omap2/gpmc.c | 42 +++++++++++++++++++++++++++++-------------
 1 file changed, 29 insertions(+), 13 deletions(-)

diff --git a/arch/arm/mach-omap2/gpmc.c b/arch/arm/mach-omap2/gpmc.c
index 8bc1338..4a4cc04 100644
--- a/arch/arm/mach-omap2/gpmc.c
+++ b/arch/arm/mach-omap2/gpmc.c
@@ -521,26 +521,42 @@ static int gpmc_cs_delete_mem(int cs)
  * "base". Returns 0 on success and appropriate negative error code
  * on failure.
  */
-static int gpmc_cs_remap(int cs, u32 base)
+static int gpmc_cs_remap(int cs, u32 base, u32 size)
 {
        int ret;
-       u32 old_base, size;
 
        if (cs > gpmc_cs_num) {
                pr_err("%s: requested chip-select is disabled\n", __func__);
                return -ENODEV;
        }
 
-       /*
-        * Make sure we ignore any device offsets from the GPMC partition
-        * allocated for the chip select and that the new base confirms
-        * to the GPMC 16MB minimum granularity.
-        */ 
-       base &= ~(SZ_16M - 1);
-
-       gpmc_cs_get_memconf(cs, &old_base, &size);
-       if (base == old_base)
-               return 0;
+       /* allocate enough address-space under GPMC chip-select to device */
+       if (size > SZ_256M) {
+               pr_err("%s: memory device > 256MB not supported\n", __func__);
+               return -ENODEV;
+       } else if (size > SZ_128M) {
+               WARN((size != SZ_256M), "cs=%d: allocating 256MB\n", cs);
+               size = SZ_256M;
+       } else if (size > SZ_64M) {
+               WARN((size != SZ_128M), "cs=%d: allocating 128MB\n", cs);
+               size = SZ_128M;
+       } else if (size > SZ_32M) {
+               WARN((size != SZ_64M), "cs=%d: allocating 64MB\n", cs);
+               size = SZ_64M;
+       } else if (size > SZ_16M) {
+               WARN((size != SZ_32M), "cs=%d: allocating 64MB\n", cs);
+               size = SZ_32M;
+       } else {
+               WARN((size != SZ_16M), "cs=%d: allocating 64MB\n", cs);
+               size = SZ_16M;
+       }
+
+       /* base address should be aligned with address-space size */
+       if (base & (size - 1)) {
+               pr_err("base-addr=%x should be aligned to size=%x", base, size);
+               return -EINVAL;
+       }
+
        gpmc_cs_disable_mem(cs);
        ret = gpmc_cs_delete_mem(cs);
        if (ret < 0)
@@ -1551,7 +1567,7 @@ static int gpmc_probe_generic_child(struct 
platform_device *pdev,
         * CS to this location. Once DT migration is complete should
         * just make gpmc_cs_request() map a specific address.
         */
-       ret = gpmc_cs_remap(cs, res.start);
+       ret = gpmc_cs_remap(cs, res.start, resource_size(&res));
        if (ret < 0) {
                dev_err(&pdev->dev, "cannot remap GPMC CS %d to %pa\n",
                        cs, &res.start);
-- 
1.8.5.1.163.gd7aced9

--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to