On Wed, Dec 23, 2015 at 12:50:20PM +0100, Paul Kocialkowski wrote:
> Le mercredi 23 décembre 2015 à 11:41 +0000, Mark Brown a écrit :

> > I would expect the driver at least needs to know how the pins or
> > strapped, or otherwise have configuration for ignoring the input on the
> > pins.  This just deletes the warnings, it doesn't have any handling for
> > this case that I can see.

> When the DVS GPIO is invalid, lp872x_init_dvs jumps to the
> set_default_dvs_mode label, which instructs the chip not to use the DVS
> pin at all and do it all in software instead (by clearing the
> LP8720_EXT_DVS_M bit in the LP872X_GENERAL_CFG register).

> That is reflected later in the code, when setting the bucks (the DVS pin
> only applies to the bucks) by checking for the LP8720_EXT_DVS_M bit on
> the LP872X_GENERAL_CFG register (in lp872x_select_buck_vout_addr) to
> decide whether to use software or hardware DVS selection.

> As far as I understood, everything goes well when the GPIO is invalid.

So please put this analysis in the changelog so that the changelog
accurately reflects what the change is doing.

Attachment: signature.asc
Description: PGP signature

Reply via email to