On Mon, Jun 06, 2011 at 03:32:29PM -0700, Kevin Hilman wrote: > Colin Cross <[email protected]> writes: > > > On Sat, Jun 4, 2011 at 12:03 PM, Colin Cross <[email protected]> wrote: > >> Setting the IRQWAKEN bit was overwriting previous IRQWAKEN bits, > >> causing only the last bit set to take effect, resulting in lost > >> wakeups when the GPIO controller is in idle. > >> > >> Replace direct writes to IRQWAKEN with writes to SETWKUENA and > >> CLEARWKUEN. > >> > >> Signed-off-by: Colin Cross <[email protected]> > > [...] > > > > > Todd pointed out that the OMAP4 TRM says not to use SETWKUENA and > > CLEARWKUENA. > > In my GPIO cleanups, I was wondering why the set/clear registers were > not used here. Todd, can you give the TRM version & reference for this? > I didn't find anything after a quick scan/search.
http://focus.ti.com/general/docs/wtbu/wtbudocumentcenter.tsp?templateId=6123&navigationId=12037 OMAP4460 Multimedia Device Silicon Revision 1.0 Version E February 2011–Revised May 2011 p. 5357 Table 25-68. GPIO_CLEARWKUPENA "Caution: This register is kept for backward software compatibility. Use GPIO_IRQWAKEN_0 and GPIO_IRQWAKEN_1 instead." OMAP4430 TRM is similar. Todd -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
