Todd Poynor <[email protected]> writes: > On Mon, Jun 06, 2011 at 03:32:29PM -0700, Kevin Hilman wrote: >> Colin Cross <[email protected]> writes: >> >> > On Sat, Jun 4, 2011 at 12:03 PM, Colin Cross <[email protected]> wrote: >> >> Setting the IRQWAKEN bit was overwriting previous IRQWAKEN bits, >> >> causing only the last bit set to take effect, resulting in lost >> >> wakeups when the GPIO controller is in idle. >> >> >> >> Replace direct writes to IRQWAKEN with writes to SETWKUENA and >> >> CLEARWKUEN. >> >> >> >> Signed-off-by: Colin Cross <[email protected]> >> >> [...] >> >> > >> > Todd pointed out that the OMAP4 TRM says not to use SETWKUENA and >> > CLEARWKUENA. >> >> In my GPIO cleanups, I was wondering why the set/clear registers were >> not used here. Todd, can you give the TRM version & reference for this? >> I didn't find anything after a quick scan/search. > > http://focus.ti.com/general/docs/wtbu/wtbudocumentcenter.tsp?templateId=6123&navigationId=12037 > > OMAP4460 Multimedia Device Silicon Revision 1.0 Version E > February 2011–Revised May 2011 > > p. 5357 Table 25-68. GPIO_CLEARWKUPENA > > "Caution: This register is kept for backward software compatibility. Use > GPIO_IRQWAKEN_0 and GPIO_IRQWAKEN_1 instead."
OK, I see it now. Thanks, Kevin -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
