On 17:11-20120306, Tero Kristo wrote:
> From: Vishwanath BS <vishwanath...@ti.com>
>
> Since IO Daisychain modifies only PRM registers, it makes sense to move
> it to PRM File. Also changed the timeout value for IO chain enable to
> 100us and added a wait for status disable at the end.
[...]
> diff --git a/arch/arm/mach-omap2/prm2xxx_3xxx.c
> b/arch/arm/mach-omap2/prm2xxx_3xxx.c
> index 9ce7654..2f45b96 100644
> --- a/arch/arm/mach-omap2/prm2xxx_3xxx.c
> +++ b/arch/arm/mach-omap2/prm2xxx_3xxx.c
> @@ -301,6 +301,43 @@ void omap3xxx_prm_restore_irqen(u32 *saved_mask)
> OMAP3_PRM_IRQENABLE_MPU_OFFSET);
> }
>
> +/*
> + * Maximum time(us) it takes to output the signal WUCLKOUT of the last pad of
> + * the I/O ring after asserting WUCLKIN high
> + */
> +#define MAX_IOPAD_LATCH_TIME 100
> +
> +/* OMAP3 Daisychain enable sequence */
> +void omap3_trigger_io_chain(void)
> +{
> + int i = 0;
> +
> + omap2_prm_set_mod_reg_bits(OMAP3430_EN_IO_CHAIN_MASK, WKUP_MOD,
> + PM_WKEN);
> + /* Do a readback to assure write has been done */
> + omap2_prm_read_mod_reg(WKUP_MOD, PM_WKEN);
> +
> + omap_test_timeout(omap2_prm_read_mod_reg(WKUP_MOD, PM_WKST) &
> + OMAP3430_ST_IO_CHAIN_MASK,
> + MAX_IOPAD_LATCH_TIME, i);
probably a nitpick, but would'nt you like to keep the OMAP3 and OMAP4
style consistent?
> +
> + omap2_prm_clear_mod_reg_bits(OMAP3430_EN_IO_CHAIN_MASK, WKUP_MOD,
> + PM_WKEN);
> +
> + omap2_prm_set_mod_reg_bits(OMAP3430_ST_IO_CHAIN_MASK, WKUP_MOD,
> + PM_WKST);
> +
> + omap2_prm_read_mod_reg(WKUP_MOD, PM_WKST);
in the previous iteration it had:
omap_test_timeout(((omap2_prm_read_mod_reg(WKUP_MOD, PM_WKST) &
OMAP3430_ST_IO_CHAIN_MASK) == 0),
MAX_IOPAD_LATCH_TIME,
i);
gone now?
--
Regards,
Nishanth Menon
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
