Take advantage of the switch to mode B for accessing the TCR register, and move the xon/xoff configuration there. This allows further simplication of this sequence.
Signed-off-by: Russell King <[email protected]> --- drivers/tty/serial/omap-serial.c | 13 +++++++------ 1 files changed, 7 insertions(+), 6 deletions(-) diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c index 22877ac..e786eac 100644 --- a/drivers/tty/serial/omap-serial.c +++ b/drivers/tty/serial/omap-serial.c @@ -871,16 +871,20 @@ serial_omap_set_termios(struct uart_port *port, struct ktermios *termios, else serial_out(up, UART_OMAP_MDR1, up->mdr1); - /* Enable access to TCR/TLR */ + /* Configure flow control */ serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B); + + /* XON1/XOFF1 accessible mode B, TCRTLR=0, ECB=0 */ + serial_out(up, UART_XON1, termios->c_cc[VSTART]); + serial_out(up, UART_XOFF1, termios->c_cc[VSTOP]); + + /* Enable access to TCR/TLR */ serial_out(up, UART_EFR, up->efr | UART_EFR_ECB); serial_out(up, UART_LCR, UART_LCR_CONF_MODE_A); serial_out(up, UART_MCR, up->mcr | UART_MCR_TCRTLR); serial_out(up, UART_TI752_TCR, OMAP_UART_TCR_TRIG); - /* Hardware Flow Control Configuration */ - if (termios->c_cflag & CRTSCTS) { /* Enable AUTORTS and AUTOCTS */ up->efr |= UART_EFR_CTS | UART_EFR_RTS; @@ -897,9 +901,6 @@ serial_omap_set_termios(struct uart_port *port, struct ktermios *termios, serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B); serial_out(up, UART_EFR, up->efr); - serial_out(up, UART_XON1, termios->c_cc[VSTART]); - serial_out(up, UART_XOFF1, termios->c_cc[VSTOP]); - /* clear SW control mode bits */ up->efr &= OMAP_UART_SW_CLR; -- 1.7.4.4 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
