I ran into this issue a while back but completely forgot how I handled it.
I have a drive in a RAID 6 config that failed. I was able to just rebuild the RAID a while back and it’s been fine for months. I think I ended up doing it via the BIOS rather than the tools because I couldn’t get past the error. In running the report I see this: # omreport storage pdisk controller=0 List of Physical Disks on Controller PERC H700 Integrated (Embedded) Controller PERC H700 Integrated (Embedded) … ID : 0:0:3 Status : Critical Name : Physical Disk 0:0:3 State : Failed Power Status : Spun Up Bus Protocol : SAS Media : HDD Part of Cache Pool : Not Applicable Remaining Rated Write Endurance : Not Applicable Failure Predicted : No Revision : FS64 Driver Version : Not Applicable Model Number : Not Applicable T10 PI Capable : No Certified : Yes Encryption Capable : No Encrypted : Not Applicable Progress : Not Applicable Mirror Set ID : Not Applicable Capacity : 278.88 GB (299439751168 bytes) Used RAID Disk Space : 278.88 GB (299439751168 bytes) Available RAID Disk Space : 0.00 GB (0 bytes) Hot Spare : No Vendor ID : DELL(tm) Product ID : ST9300603SS Serial No. : 6SE4DTMB Part Number : CN0T871K7262216J05VHA01 Negotiated Speed : 6.00 Gbps Capable Speed : 6.00 Gbps PCIe Negotiated Link Width : Not Applicable PCIe Maximum Link Width : Not Applicable Sector Size : 512B Device Write Cache : Not Applicable Manufacture Day : 03 Manufacture Week : 25 Manufacture Year : 2011 SAS Address : 5000C5003B697F25 Non-RAID HDD Disk Cache Policy : Not Applicable Disk Cache Policy : Not Applicable Form Factor : Not Available Sub Vendor : Not Available ISE Capable : No … So I then try to repair/rebuild it. # /opt/dell/srvadmin/sbin/omconfig storage pdisk action=rebuild controller=0 pdisk=0:0:3 Operation disabled. Read, action=rebuild Refer to the documentation for more information. I seem to recall that when I did it via the BIOS I had to remove the drive and then rebuild it as a spare. Is it the same via the CLI. Is there a way to get past this? Thank you, Steffan Cline 602-793-0014
_______________________________________________ Linux-PowerEdge mailing list [email protected] https://lists.us.dell.com/mailman/listinfo/linux-poweredge
