Hi, > Intel d815 motherboard > primary-> Seagate 20g (master) hda > secondary-> Seagate 20g (master) hdc > Promise Ultra66 (PDC20262) > primary-> Seagate 20g (master) hdg > secondary-> Seagate 20g (master) hdh > > I'm trying to install with the following configuration: > hda > 16 ----> /boot > 300 ----> swap > 10000 ----> part of RAID 5 "/" > hdc > 10000 ----> part of RAID 5 "/" > hdg > 10000 ----> part of RAID 5 "/" > hdh > 10000 ----> part of RAID 5 "/" > > "/" on RAID 5 spanned across all 4 Seagates (except for a /boot and a > swap partition will be regular non-raid partitions on hda). > > PROBLEM: > - If I use the stock RedHat CD, I get to the graphical installation, > but I can't see the promise card. So I can configure RAID just fine > on the 2 hdd's connected to the motherboard. there is no way to setup directly promise with radhat 6.2. what we do is to use the hda/hdc from mother cart with graphics setup then once is done, plug the cables on the promise. We did not arrive to use in raid-soft 2 hd on 1 promise. For exemple 4x40Go we used 2 promise 66. > - However, it only boots into text mode for some reason (Any > comments, Mike Brancato?). In text mode, is there anyway to configure > a RAID device? I don't see the "Make RAID device" button anywhere. > Maybe someone could spell out the baby steps if it is indeed possible. no way to make raid in text mode. Amicalement, oCtAvE "Peu importe ce qu'il y a de l'autre c�t�. Tout ce qu'on laisse ici n'est qu'une histoire dont on se souviendra ou pas." - To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [EMAIL PROTECTED]
