Hello
I'm having problems with a RAID-1 configuration. I cannot re-add a disk
that I've failed, because each time I do this, the re-added disk is
still seen as failed.
After some investigations, I found that this problem only occur when I
create the RAID array with superblocks 1.0, 1.1 and 1.2.
With the superblock 0.90 I don't encounter this issue.
Here are the commands to easily reproduce the issue
mdadm -C /dev/md_d0 -e 1.0 -l 1 -n 2 -b internal -R /dev/sda /dev/sdb
mdadm /dev/md_d0 -f /dev/sda
mdadm /dev/md_d0 -r /dev/sda
mdadm /dev/md_d0 -a /dev/sda
cat /proc/mdstat
The output of mdstat is:
Personalities : [raid1]
md_d0 : active raid1 sda[0](F) sdb[1]
104849 blocks super 1.2 [2/1] [_U]
bitmap: 0/7 pages [0KB], 8KB chunk
unused devices: <none>
I'm wondering if the way I'm failing and re-adding a disk is correct.
Did I make something wrong?
If I change the superblock to "-e 0.90", there's no problem with this
set of commands.
For now, I found a work-around with superblock 1.0 which consists in
zeroing the superblock before re-adding the disk. But I suppose that
doing so will force a full rebuild of the re-added disk, and I don't
want this, because I'm using write-intent bitmaps.
I'm using mdadm - v2.5.6 on Debian Etch with kernel 2.6.18-4.
Bug or misunderstanding from myself? Any help would be appreciated :)
Thanks
Hubert
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
