OK, If I compile the aic7xxx support into the kernel I get the following
message over and over when trying to configure 2930 controller. If it is
compiled as a module my first PCI SCSI Card works fine (2940U2W), but the
2930 is only seen by the BIOS, but not acknoledged by the kernel.
SCSI0:-1:-1:-1) Referenced SCB 13 not valid during SELTO
SCSISEQ=0x5a SEQADDR=0x8 SSATO=0x10 SSTAT1=0x88
SCSI0:-1:-1:-1) Referenced SCB 13 not valid during SELTO
SCSISEQ=0x5a SEQADDR=0x9 SSATO=0x10 SSTAT1=0x88
(These are repeated many times, then it says:)
SCSI Host 1 channel 0 reset(PID 74) Timed out-trying harder
SCSI Bus is being reset for host 1 channel 0
(Then it does the above lines many times, and ......over and over till I
stop it)
Any ideas?
Pat
---------------------------------------------------
Patrick Heath
Network Administrator
Fred Hutchinson Cancer Research Center
1100 Fairview Avenue North, A1-162
Seattle, WA 98109
Email: [EMAIL PROTECTED]
Phone: (206) 667-2000
Fax: (206) 667-6525
---------------------------------------------------
