On 01/15/2017 03:31 PM, Jonathan Cameron wrote: > On 15/01/17 14:13, jacopo mondi wrote: >> Hi Jonathan, >> thanks for review, >> >> On 13/01/2017 10:50, Jacopo Mondi wrote: >>> Hello, >>> sending out v4 splitting device tree bindings documentation and actual >>> ADC >>> driver. >>> No changes in driver code since v3. >>> >>> Same question for iio maintainers here: >>> I would like to have clarified the measure unit returned by read_raw(). >>> Currently (value_raw * value_scale) return the ADC input value in mV. > Good. >>> While testing the patch I've been questioned if that should not actually >>> be in uV. This is easily achievable making _scale return a value in uV. >>> I have found no mention of this in the ABI documentation as it speaks of >>> generic voltage. Can we have a final word on this? >> >> I see you have reviewed the driver without complaining for the >> read_raw() measure unit, so I assume this replies to the above >> question as well... >> > The units are specified in Documentation/ABI/testing/sysfs-bus-iio. > >> What: /sys/bus/iio/devices/iio:deviceX/in_voltageY_raw >> What: /sys/bus/iio/devices/iio:deviceX/in_voltageY_supply_raw >> What: /sys/bus/iio/devices/iio:deviceX/in_voltageY_i_raw >> What: /sys/bus/iio/devices/iio:deviceX/in_voltageY_q_raw >> KernelVersion: 2.6.35 >> Contact: [email protected] >> Description: >> Raw (unscaled no bias removal etc.) voltage measurement from >> channel Y. In special cases where the channel does not >> correspond to externally available input one of the named >> versions may be used. The number must always be specified and >> unique to allow association with event codes. Units after >> application of scale and offset are millivolts. > > So millivolts. This comes from a, perhaps ill judged, decision to match > hwmon units were we could.
Fun, regulator framework returns values in uV to add to the chaos :) -- Best regards, Marek Vasut
