This patch enables usb3_peri0 that uses usb3_phy0 to enable VBUS
detection for the USB3.0 peripheral.
The Salvator-X[S] has USB3.0 type-A connector and supplies VBUS
if USB3.0 host runs. So, you need a special cable for it, and
to stop the VBUS supplies from the board, after you installs
a gadget driver, you should run the following command to avoid
conflict VBUS supply:
# echo 1 > /sys/kernel/debug/ee020000.usb/b_device
Signed-off-by: Yoshihiro Shimoda <[email protected]>
---
arch/arm64/boot/dts/renesas/salvator-common.dtsi | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/arch/arm64/boot/dts/renesas/salvator-common.dtsi
b/arch/arm64/boot/dts/renesas/salvator-common.dtsi
index f7c8ced..8e01fb9 100644
--- a/arch/arm64/boot/dts/renesas/salvator-common.dtsi
+++ b/arch/arm64/boot/dts/renesas/salvator-common.dtsi
@@ -666,6 +666,13 @@
status = "okay";
};
+&usb3_peri0 {
+ phys = <&usb3_phy0>;
+ phy-names = "usb";
+
+ status = "okay";
+};
+
&usb3_phy0 {
status = "okay";
};
--
1.9.1
