According to section 59.2.4 MSIOF Receive Mode Register 1 (SIRMDR1) in the R-Car Gen3 datasheet Rev.1.00, the value of the SIRMDR1.SYNCAC bit must match the value of the SITMDR1.SYNCAC bit. However, sh_msiof_spi_setup() changes only the latter.
Fix this by updating the SIRMDR1 register like the SITMDR1 register, taking into account register bits that exist in SITMDR1 only. Reported-by: Renesas BSP team via Yoshihiro Shimoda <[email protected]> Fixes: 7ff0b53c4051145d ("spi: sh-msiof: Avoid writing to registers from spi_master.setup()") Signed-off-by: Geert Uytterhoeven <[email protected]> --- drivers/spi/spi-sh-msiof.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/drivers/spi/spi-sh-msiof.c b/drivers/spi/spi-sh-msiof.c index 244e841fc4bcfcc7..09c04c1b7d0b5a15 100644 --- a/drivers/spi/spi-sh-msiof.c +++ b/drivers/spi/spi-sh-msiof.c @@ -567,14 +567,16 @@ static int sh_msiof_spi_setup(struct spi_device *spi) /* Configure native chip select mode/polarity early */ clr = MDR1_SYNCMD_MASK; - set = MDR1_TRMD | TMDR1_PCON | MDR1_SYNCMD_SPI; + set = MDR1_SYNCMD_SPI; if (spi->mode & SPI_CS_HIGH) clr |= BIT(MDR1_SYNCAC_SHIFT); else set |= BIT(MDR1_SYNCAC_SHIFT); pm_runtime_get_sync(&p->pdev->dev); tmp = sh_msiof_read(p, TMDR1) & ~clr; - sh_msiof_write(p, TMDR1, tmp | set); + sh_msiof_write(p, TMDR1, tmp | set | MDR1_TRMD | TMDR1_PCON); + tmp = sh_msiof_read(p, RMDR1) & ~clr; + sh_msiof_write(p, RMDR1, tmp | set); pm_runtime_put(&p->pdev->dev); p->native_cs_high = spi->mode & SPI_CS_HIGH; p->native_cs_inited = true; -- 2.7.4
