Hi Rob,
On Wednesday, 23 May 2018 19:29:47 EEST Rob Herring wrote:
> On Wed, May 16, 2018 at 06:32:27PM +0200, Jacopo Mondi wrote:
> > Describe the optional endpoint properties for endpoint nodes of port@0
> > and port@1 of the R-Car VIN driver device tree bindings documentation.
> >
> > Signed-off-by: Jacopo Mondi <[email protected]>
> > ---
> >
> > Documentation/devicetree/bindings/media/rcar_vin.txt | 13 ++++++++++++-
> > 1 file changed, 12 insertions(+), 1 deletion(-)
> >
> > diff --git a/Documentation/devicetree/bindings/media/rcar_vin.txt
> > b/Documentation/devicetree/bindings/media/rcar_vin.txt index
> > a19517e1..c53ce4e 100644
> > --- a/Documentation/devicetree/bindings/media/rcar_vin.txt
> > +++ b/Documentation/devicetree/bindings/media/rcar_vin.txt
> > @@ -53,6 +53,16 @@ from local SoC CSI-2 receivers (port1) depending on
> > SoC.
> >
> > from external SoC pins described in video-interfaces.txt[1].
> > Describing more then one endpoint in port 0 is invalid. Only VIN
> > instances that are connected to external pins should have port 0.
> >
> > +
> > + - Optional properties for endpoint nodes of port@0:
> > + - hsync-active: active state of the HSYNC signal, 0/1 for
> > LOW/HIGH
> > + respectively. Default is active high.
> > + - vsync-active: active state of the VSYNC signal, 0/1 for
> > LOW/HIGH
> > + respectively. Default is active high.
> > +
> > + If both HSYNC and VSYNC polarities are not specified, embedded
> > + synchronization is selected.
>
> No need to copy-n-paste from video-interfaces.txt. Just "see
> video-interfaces.txt" for the description is fine.
I would still explicitly list the properties that apply to this binding. I
agree that there's no need to copy & paste the description of those properties
though.
> > +
> >
> > - port 1 - sub-nodes describing one or more endpoints connected to
> >
> > the VIN from local SoC CSI-2 receivers. The endpoint numbers must
> > use the following schema.
> >
> > @@ -62,6 +72,8 @@ from local SoC CSI-2 receivers (port1) depending on SoC.
> >
> > - Endpoint 2 - sub-node describing the endpoint connected to
> > CSI40
> > - Endpoint 3 - sub-node describing the endpoint connected to
> > CSI41
> >
> > + Endpoint nodes of port@1 do not support any optional endpoint
> > property. +
> >
> > Device node example for Gen2 platforms
> > --------------------------------------
> >
> > @@ -112,7 +124,6 @@ Board setup example for Gen2 platforms (vin1 composite
> > video input)>
> > vin1ep0: endpoint {
> >
> > remote-endpoint = <&adv7180>;
> >
> > - bus-width = <8>;
> >
> > };
> >
> > };
> >
> > };
--
Regards,
Laurent Pinchart
