On Tue, Nov 06, 2018 at 11:57:17AM +0100, Wolfram Sang wrote: > On Sun, Nov 04, 2018 at 09:37:07PM +0100, Marek Vasut wrote: > > The eMMC card has two supplies, VCC and VCCQ. The VCC supplies the NAND > > array and the VCCQ supplies the bus. On Salvator-X and ULCB, the VCC is > > connected to 3.3V rail, while the VCCQ is connected to 1.8V rail. Adjust > > the pinmux to match the bus, which is always operating in 1.8V mode. > > > > While at it, deduplicate the pinmux entries, which are now the same for > > both default and UHS modes. We still need the two pinctrl entries to > > match the bindings though. > > > > Signed-off-by: Marek Vasut <[email protected]> > > Cc: Geert Uytterhoeven <[email protected]> > > Cc: Simon Horman <[email protected]> > > Cc: Wolfram Sang <[email protected]> > > Cc: Yoshihiro Shimoda <[email protected]> > > Cc: [email protected] > > Cc: [email protected] > > Tested on M3-N and H3 ES2.0 with HS400 enabled eMMC: > > Reviewed-by: Wolfram Sang <[email protected]> > Tested-by: Wolfram Sang <[email protected]>
Thanks, applied for v4.21.
