Mark Brown wrote: > > When gpio_request() fails the driver logged the failure but while it'd > try to print an error code in the non-DT case it didn't pass the error > code in so garbage would be logged and in the DT case the error wasn't > logged. > > Further, in the non-DT case the error code was then overwritten with - > EBUSY > depriving the caller of information and breaking automatic probe deferral > pushing back from the GPIO level. Also reformat the non-DT log message > so it's not word wrapped and we can grep for it. > > Signed-off-by: Mark Brown <[email protected]> > --- > drivers/spi/spi-s3c64xx.c | 9 +++++---- > 1 file changed, 5 insertions(+), 4 deletions(-) > > diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c > index 999154a0..7258b18 100644 > --- a/drivers/spi/spi-s3c64xx.c > +++ b/drivers/spi/spi-s3c64xx.c > @@ -894,9 +894,9 @@ static int s3c64xx_spi_setup(struct spi_device *spi) > if (!spi_get_ctldata(spi)) { > err = gpio_request(cs->line, dev_name(&spi->dev)); > if (err) { > - dev_err(&spi->dev, "request for slave select gpio " > - "line [%d] failed\n", cs->line); > - err = -EBUSY; > + dev_err(&spi->dev, > + "Failed to get /CS gpio [%d]: %d\n", > + cs->line, err); > goto err_gpio_req; > } > spi_set_ctldata(spi, cs); > @@ -1114,7 +1114,8 @@ static int s3c64xx_spi_parse_dt_gpio(struct > s3c64xx_spi_driver_data *sdd) > > ret = gpio_request(gpio, "spi-bus"); > if (ret) { > - dev_err(dev, "gpio [%d] request failed\n", gpio); > + dev_err(dev, "gpio [%d] request failed: %d\n", > + gpio, ret); > goto free_gpio; > } > } > -- > 1.7.10.4
Mark, thanks for your re-work 3th and 4th patches in this series :-) Looks good to me, applied this series. Thanks. Best regards, Kgene. -- Kukjin Kim <[email protected]>, Senior Engineer, SW Solution Development Team, Samsung Electronics Co., Ltd. -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
