On Wed, 4 Apr 2018 15:51:38 +0900
Damien Le Moal <[email protected]> wrote:
> With the introduction of commit e39a97353e53 ("scsi: core: return
> BLK_STS_OK for DID_OK in __scsi_error_from_host_byte()"), a command
> that failed with hostbyte=DID_OK and driverbyte=DRIVER_SENSE but
> lacking additional sense information will have a return code set to
> BLK_STS_OK. This results in the request issuer to see successful
> request execution despite the failure. An example of such case is an
> unaligned write on a host managed ZAC disk connected to a SAS HBA
> with a malfunctioning SAT. The unaligned write command gets aborted
> but has no additional sense information.
>
> sd 10:0:0:0: [sde] tag#3905 FAILED Result: hostbyte=DID_OK
> driverbyte=DRIVER_SENSE sd 10:0:0:0: [sde] tag#3905 Sense Key :
> Aborted Command [current] sd 10:0:0:0: [sde] tag#3905 Add. Sense: No
> additional sense information sd 10:0:0:0: [sde] tag#3905 CDB:
> Write(16) 8a 00 00 00 00 00 02 0c 00 01 00 00 00 01 00 00
> print_req_error: I/O error, dev sde, sector 274726920
>
> In scsi_io_completion(), sense key handling to not change the request
> error code and success being reported to the issuer.
>
> Fix this by making sure that the error code always indicates an error
> if scsi_io_completion() decide that the action to be taken for a
> failed command is to not retry it and terminate it immediately
> (ACTION_FAIL) .
>
> Signed-off-by: Damien Le Moal <[email protected]>
> Fixes: e39a97353e53 ("scsi: core: return BLK_STS_OK for DID_OK in
> __scsi_error_from_host_byte()") Cc: Hannes Reinecke <[email protected]>
> Cc: <[email protected]>
> ---
> drivers/scsi/scsi_lib.c | 9 +++++++++
> 1 file changed, 9 insertions(+)
>
> diff --git a/drivers/scsi/scsi_lib.c b/drivers/scsi/scsi_lib.c
> index c84f931388f2..87579bfcc186 100644
> --- a/drivers/scsi/scsi_lib.c
> +++ b/drivers/scsi/scsi_lib.c
> @@ -1002,6 +1002,15 @@ void scsi_io_completion(struct scsi_cmnd *cmd,
> unsigned int good_bytes) scsi_print_command(cmd);
> }
> }
> + /*
> + * The command failed and should not be retried. If
> the host
> + * byte is DID_OK, then
> __scsi_error_from_host_byte() returned
> + * BLK_STS_OK and error indicates a success. Make
> sure to not
> + * use that as the completion code and always return
> an
> + * I/O error.
> + */
> + if (error == BLK_STS_OK)
> + error = BLK_STS_IOERR;
> if (!scsi_end_request(req, error,
> blk_rq_err_bytes(req), 0)) return;
> /*FALLTHRU*/
That looks wrong.
Shouldn't __scsi_error_from_host_byte() return the correct status here?
Cheers,
Hannes
