I had not gotten far enough to try the FWD devices; I was only trying the SE
devices. I returned the card after a careful reading of the instructions
indicated that it wouldn't drive the FWD (and a call to Adaptec confirmed
this).
-----Original Message-----
From: Doug Ledford [mailto:[EMAIL PROTECTED]]
Sent: Friday, January 29, 1999 1:32 AM
To: Allison, Bob
Cc: '[EMAIL PROTECTED]'; [EMAIL PROTECTED]
Subject: Re: Adaptec 2940UW controller driver for Linux
"Allison, Bob" wrote:
>
> I'm not sure what you mean by the UW and U2W connectors. The U2W only had
> one 50-pin ribbon cable connector.
The 50 pin connector on a U2W is on the SE only bus segment (aka, behind
the 3860 chip). It is entirely possible that the 3860 could have been
bad.
> I believe that the last device on the
> chain is providing termination, but I don't know if it is active or
passive;
> since these are SCSI-2 devices and not Ultras, I would assume that they
> don't know what active terminators are.
Active came about with SCSI-2 and was simply even more important when
Ultra started to appear. Devices capable of 10MByte/s narrow transfers
should use active termination, but if they have resistor packs for
termination, then it isn't active :)
> BTW, I sent the card back where it came from and got the 2944UW in its
> place, so I am running fine with my older FWD devices on the 2944 and my
SE
> devices on the 2940. (I don't have any Ultra-SCSI devices.)
They way you said this, it almost sounds like you had the FWD on the
Ultra2 card. That does *not* work, the U2W card only supports SE and
LVD devices, not older HVD devices. That could have been a problem as
well.
--
Doug Ledford <[EMAIL PROTECTED]>
Opinions expressed are my own, but
they should be everybody's.
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
