The problem:
- U160 adaptec
- remove-single-device, then add-single-device works fine
- if you switch off the drive in middle, the next time it
is re-added, it presumably doesn't negociate synchronous
- (using an isolated bus backplane)
My question: (will try to use the source anyway :))
- is add-single-device supposed to cause renegociation for that
device ? That may not work unless there is some way we can tell
the HA that this is a rescan.
This is a bit on the side of the `start unit' concern.
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
