On 20.08.2015 04:54, Heiner Kallweit wrote: > Extend the driver to make full use of runtime PM autosuspend. > Before only the SPI core was instructed to use autosuspend > by setting master->auto_runtime_pm. Nevertheless due to the missing > pm_runtime_use_autosuspend call autosuspend wasn't active. > > Signed-off-by: Heiner Kallweit <[email protected]> > --- > drivers/spi/spi-s3c64xx.c | 12 ++++++++++-- > 1 file changed, 10 insertions(+), 2 deletions(-)
I am a little bit confused... it's the same patch? It's not marked as resend, not marked as v2 and there is no changelog... Best regards, Krzysztof > > diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c > index 8a6ab88..8365c88 100644 > --- a/drivers/spi/spi-s3c64xx.c > +++ b/drivers/spi/spi-s3c64xx.c > @@ -32,6 +32,7 @@ > #define MAX_SPI_PORTS 6 > #define S3C64XX_SPI_QUIRK_POLL (1 << 0) > #define S3C64XX_SPI_QUIRK_CS_AUTO (1 << 1) > +#define AUTOSUSPEND_TIMEOUT 2000 > > /* Registers and bit-fields */ > > @@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi) > } > } > > - pm_runtime_put(&sdd->pdev->dev); > + pm_runtime_mark_last_busy(&sdd->pdev->dev); > + pm_runtime_put_autosuspend(&sdd->pdev->dev); > if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO)) > writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + > S3C64XX_SPI_SLAVE_SEL); > return 0; > > setup_exit: > - pm_runtime_put(&sdd->pdev->dev); > + pm_runtime_mark_last_busy(&sdd->pdev->dev); > + pm_runtime_put_autosuspend(&sdd->pdev->dev); > /* setup() returns with device de-selected */ > if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO)) > writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + > S3C64XX_SPI_SLAVE_SEL); > @@ -1180,6 +1183,8 @@ static int s3c64xx_spi_probe(struct platform_device > *pdev) > S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN, > sdd->regs + S3C64XX_SPI_INT_EN); > > + pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT); > + pm_runtime_use_autosuspend(&pdev->dev); > pm_runtime_set_active(&pdev->dev); > pm_runtime_enable(&pdev->dev); > > @@ -1195,6 +1200,9 @@ static int s3c64xx_spi_probe(struct platform_device > *pdev) > mem_res, (FIFO_LVL_MASK(sdd) >> 1) + 1, > sdd->rx_dma.dmach, sdd->tx_dma.dmach); > > + pm_runtime_mark_last_busy(&pdev->dev); > + pm_runtime_autosuspend(&pdev->dev); > + > return 0; > > err4: > -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
