Am 20.08.2015 um 01:46 schrieb Krzysztof Kozlowski: > On 20.08.2015 04:54, Heiner Kallweit wrote: >> Extend the driver to make full use of runtime PM autosuspend. >> Before only the SPI core was instructed to use autosuspend >> by setting master->auto_runtime_pm. Nevertheless due to the missing >> pm_runtime_use_autosuspend call autosuspend wasn't active. >> >> Signed-off-by: Heiner Kallweit <[email protected]> >> --- >> drivers/spi/spi-s3c64xx.c | 12 ++++++++++-- >> 1 file changed, 10 insertions(+), 2 deletions(-) > > > I am a little bit confused... it's the same patch? It's not marked as > resend, not marked as v2 and there is no changelog... > > Best regards, > Krzysztof The structure of the patchset significantly changed, therefore I didn't mark it as v2. But you're right, should have done it. Will send a v2 incl. the changes based on your remarks + changelog.
Regards, Heiner >> >> diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c >> index 8a6ab88..8365c88 100644 >> --- a/drivers/spi/spi-s3c64xx.c >> +++ b/drivers/spi/spi-s3c64xx.c >> @@ -32,6 +32,7 @@ >> #define MAX_SPI_PORTS 6 >> #define S3C64XX_SPI_QUIRK_POLL (1 << 0) >> #define S3C64XX_SPI_QUIRK_CS_AUTO (1 << 1) >> +#define AUTOSUSPEND_TIMEOUT 2000 >> >> /* Registers and bit-fields */ >> >> @@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi) >> } >> } >> >> - pm_runtime_put(&sdd->pdev->dev); >> + pm_runtime_mark_last_busy(&sdd->pdev->dev); >> + pm_runtime_put_autosuspend(&sdd->pdev->dev); >> if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO)) >> writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + >> S3C64XX_SPI_SLAVE_SEL); >> return 0; >> >> setup_exit: >> - pm_runtime_put(&sdd->pdev->dev); >> + pm_runtime_mark_last_busy(&sdd->pdev->dev); >> + pm_runtime_put_autosuspend(&sdd->pdev->dev); >> /* setup() returns with device de-selected */ >> if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO)) >> writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + >> S3C64XX_SPI_SLAVE_SEL); >> @@ -1180,6 +1183,8 @@ static int s3c64xx_spi_probe(struct platform_device >> *pdev) >> S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN, >> sdd->regs + S3C64XX_SPI_INT_EN); >> >> + pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT); >> + pm_runtime_use_autosuspend(&pdev->dev); >> pm_runtime_set_active(&pdev->dev); >> pm_runtime_enable(&pdev->dev); >> >> @@ -1195,6 +1200,9 @@ static int s3c64xx_spi_probe(struct platform_device >> *pdev) >> mem_res, (FIFO_LVL_MASK(sdd) >> 1) + 1, >> sdd->rx_dma.dmach, sdd->tx_dma.dmach); >> >> + pm_runtime_mark_last_busy(&pdev->dev); >> + pm_runtime_autosuspend(&pdev->dev); >> + >> return 0; >> >> err4: >> > > -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
