I truncated that, here is the rest. Note the big gap between 2.46 and 7.56 seconds. That is rootwait waiting for the rootfs to be ready.
Ethernet link speed detection is quite slow on Cubietruck, it takes about 5 seconds. [ 2.469611] ALSA device list: [ 2.472576] #0: sunxi-codec [ 6.413473] stmmaceth 1c50000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx [ 7.567446] VFS: Mounted root (nfs filesystem) readonly on device 0:14. [ 7.574763] devtmpfs: mounted [ 7.578283] Freeing unused kernel memory: 496K (c07cf000 - c084b000) SELinux: Could not open policy file <= /etc/selinux/targeted/policy/policy.29: No such file or directory [ 8.117344] random: init urandom read with 27 bits of entropy available [ 8.485861] init: plymouth-upstart-bridge main process (74) terminated with status 1 [ 8.494583] init: plymouth-upstart-bridge main process ended, respawning [ 8.616313] init: plymouth-upstart-bridge main process (84) terminated with status 1 [ 8.624348] init: plymouth-upstart-bridge main process ended, respawning [ 8.726702] init: ureadahead main process (77) terminated with status 5 [ 14.247522] brcmfmac: brcmf_c_preinit_dcmds: Firmware version = wl0: Apr 22 2013 14:50:00 version 5.90.195.89.6 FWID 01-b30a427d [ 14.265684] brcmfmac: brcmf_fil_cmd_data: Failed err=-23 [ 14.272651] brcmfmac: brcmf_fil_cmd_data: Failed err=-23 [ 14.278901] brcmfmac: brcmf_fil_cmd_data: Failed err=-23 [ 14.289378] brcmfmac: brcmf_fil_cmd_data: Failed err=-23 [ 14.295926] brcmfmac: brcmf_fil_cmd_data: Failed err=-23 [ 14.305150] brcmfmac: brcmf_fil_cmd_data: Failed err=-23 * Stopping Send an event to indicate plymouth is up [ OK ] * Starting Mount filesystems on boot [ OK ] * Starting Populate /dev filesystem [ OK ] * Stopping Populate /dev filesystem [ OK ] * Starting Signal sysvinit that the rootfs is mounted [ OK ] * Starting Populate and link to /run filesystem [ OK ] * Stopping Populate and link to /run filesystem [ OK ] * Stopping Track if upstart is running in a container [ OK ] * Starting Initialize or finalize resolvconf [ OK ] * Starting Clean /tmp directory [ OK ] * Stopping Clean /tmp directory [ OK ] * Starting Signal sysvinit that virtual filesystems are mounted [ OK ] * Starting Signal sysvinit that virtual filesystems are mounted [ OK ] * Starting Bridge udev events into upstart [ OK ] * Starting Signal sysvinit that local filesystems are mounted [ OK ] * Starting Signal sysvinit that remote filesystems are mounted [ OK ] * Starting device node and kernel event manager [ OK ] * Starting flush early job output to logs [ OK ] * Starting Load gator driver module and launch gator daemon [ OK ] * Stopping Mount filesystems on boot [ OK ] * Stopping flush early job output to logs [ OK ] * Starting load modules from /etc/modules [ OK ] * Starting log initial device creation [ OK ] * Starting D-Bus system message bus [ OK ] * Stopping load modules from /etc/modules [ OK ] * Starting SystemD login management service [ OK ] * Starting system logging daemon [ OK ] * Stopping cold plug devices [ OK ] * Starting configure network device security [ OK ] * Starting configure network device security [ OK ] * Stopping log initial device creation [ OK ] * Starting configure network device security [ OK ] * Starting configure network device [ OK ] * Starting save udev log and update rules [ OK ] * Starting set console font [ OK ] * Stopping set console font [ OK ] * Starting userspace bootsplash [ OK ] * Starting configure network device security [ OK ] * Stopping save udev log and update rules [ OK ] * Stopping userspace bootsplash [ OK ] * Starting Mount network filesystems [ OK ] * Starting Failsafe Boot Delay [ OK ] * Starting Send an event to indicate plymouth is up [ OK ] * Starting configure network device [ OK ] * Starting configure virtual network devices [ OK ] * Stopping Mount network filesystems [ OK ] * Starting configure network device [ OK ] * Stopping Failsafe Boot Delay [ OK ] * Stopping Send an event to indicate plymouth is up [ OK ] * Starting System V initialisation compatibility [ OK ] * Starting Bridge socket events into upstart [ OK ] * Setting sensors limits [ OK ] * Starting Bridge file events into upstart [ OK ] * Setting up X socket directories... [ OK ] * Stopping System V initialisation compatibility [ OK ] * Starting System V runlevel compatibility [ OK ] * Starting save kernel messages [ OK ] * Starting Restore Sound Card State [ OK ] * Starting regular background program processing daemon [ OK ] * Stopping Restore Sound Card State [ OK ] * Stopping Restore Sound Card State [ OK ] * Loading cpufreq kernel modules... [ OK ] * Stopping save kernel messages [ OK ] * disabled, governor not available... [ OK ] * CPUFreq Utilities: Setting ondemand CPUFreq governor... * Starting internet superserver inetd [ OK ] * Not running within Xen or no compatible utils * No usable Xen toolstack selected * Stopping System V runlevel compatibility [ OK ] -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
