Enable the micro-sd slot on the A80 Optimus Board, which is connected to mmc0. This adds the card-detect gpio and enables mmc0.
This patch also adds a 3V fixed regulator, which is the default I/O voltage level. Signed-off-by: Chen-Yu Tsai <[email protected]> Signed-off-by: Andreas Färber <[email protected]> --- arch/arm/boot/dts/sun9i-a80-optimus.dts | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+) diff --git a/arch/arm/boot/dts/sun9i-a80-optimus.dts b/arch/arm/boot/dts/sun9i-a80-optimus.dts index 506948f..02a4aa7 100644 --- a/arch/arm/boot/dts/sun9i-a80-optimus.dts +++ b/arch/arm/boot/dts/sun9i-a80-optimus.dts @@ -59,6 +59,16 @@ }; soc { + mmc0: mmc@01c0f000 { + pinctrl-names = "default"; + pinctrl-0 = <&mmc0_pins>, <&mmc0_cd_pin_optimus>; + vmmc-supply = <®_vcc3v0>; + bus-width = <4>; + cd-gpios = <&pio 7 18 0>; /* PH8 */ + cd-inverted; + status = "okay"; + }; + pio: pinctrl@06000800 { i2c3_pins_a: i2c3@0 { /* Enable internal pull-up */ @@ -72,6 +82,13 @@ allwinner,pull = <0>; }; + mmc0_cd_pin_optimus: mmc0_cd_pin@0 { + allwinner,pins = "PH18"; + allwinner,function = "gpio_in"; + allwinner,drive = <0>; + allwinner,pull = <1>; + }; + uart4_pins_a: uart4@0 { /* Enable internal pull-up */ allwinner,pull = <1>; @@ -116,4 +133,11 @@ gpios = <&pio 7 0 0>; }; }; + + reg_vcc3v0: vcc3v0 { + compatible = "regulator-fixed"; + regulator-name = "vcc3v0"; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + }; }; -- 2.1.3 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
