> > usb0 (otg): usb-a receptacle 1 (labeled 1 on the box, 0 on the print) > usb1 (ehci): routed to internal wifi > usb2 (ehci): usb-a receptacle 2 (labeled 2 on both the box and the print) > > I'm using fel mode with an usb-a <-> usb-a cable connected to usb0 on > the cs908. The cs908 has no fel button, so I've hooked up the serial > console, > and then keep 2 pressed on the serial console while inserting the usb-a > into > the PC (which will also power the board). boot0 from the nand will then > jump > into fel mode when it sees the 2 keypress. >
Hi Hans, I'm looking to try this on my vidon box which like the cs908 doesn't have OTG or a fel button. Just would like to confirm the wiring on the usb-a 2 usb-a male cable. Are they connected one to one i.e. 5v <-> 5v, D+ <-> D+ etc or are the data lines twisted. i.e. D+ <-> D- and vice versa?. Good work with the A31 and A23 deliveries. Thanks, CK > > This was an interesting exercise to confirm that everything on the A31s > just > works with A31 code, but now that is confirms A31s devices are not all that > interesting anymore :) > > I wonder wether to put URL in the commit log is the right thing >> though. It's most likely to be dead in a very near future. The cover >> letter would be a better fit for that. >> > > Ok, I'll drop it from the commit message. > > Regards, > > Hans > > -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
