Am 28.01.2015 um 10:46 schrieb Don Saklad:
How do you get the Neal Peacock PengPod1000 tablets to work from the
included SD card?...
As I could not find any Device Page in linux-sunxi.org wiki ...
manufacturer's website is not available ... it will be a problem to help
you.
Either get contact to the manufacturer for support, or first try to work
through http://linux-sunxi.org/New_Device_howto
Chances to get help are better then.
Regards
trying a variety of buttons didn't do it yet:
. PowerButton
. VolumeRockerButton
. ResetButton
. HomeButton
. Button combinations
. Holding a couple seconds
. Holding a few seconds
. Holding longer
. Holding even longer
. Tap Release
...?
A handmade instruction sheet indicates:
"To boot into Linux you must have either a Linux SD card or a device
flashed with Linux. To boot from the Linux SD, starting in Android,
insert the card (it will show as 'damaged') and reset the device. The
screen should be blank for 15-30 seconds then boot into Linux."
When from time to time and the few times it works that blank screen
fails to give a response letting users know it's working after following
the procedure in the instructions then waiting out each attempt that
failed over and over!
Any of you kind folks out there adept at it?... How!?
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
