Am 28.01.2015 um 14:41 schrieb Don Saklad:
Andreas Baierl <[email protected]> writes:
Am 28.01.2015 um 10:46 schrieb Don Saklad:
How do you get the Neal Peacock PengPod1000 tablets to work from the
included SD card?...
As I could not find any Device Page in linux-sunxi.org wiki ...
Button use isn't in related materials at
http://pengpoduse.blogspot.com
This is a somewhat user's blog....
Nothing to do with the vendor.
manufacturer's website is not available ... it will be a problem to
help you.
Either get contact to the manufacturer for support, or first try to
work through
http://linux-sunxi.org/New_Device_howto
Chances to get help are better then.
Regards
To make it clearer:
If you are not working through
http://linux-sunxi.org/New_Device_howto ,
the chances to get help from linux-sunxi community (including this mailing
list) are very small.
Regards
Andreas
trying a variety of buttons didn't do it yet:
. PowerButton
. VolumeRockerButton
. ResetButton
. HomeButton
. Button combinations
. Holding a couple seconds
. Holding a few seconds
. Holding longer
. Holding even longer
. Tap Release
...?
A handmade instruction sheet indicates:
"To boot into Linux you must have either a Linux SD card or a
device flashed with Linux. To boot from the Linux SD, starting
in Android, insert the card (it will show as 'damaged') and
reset the device. The screen should be blank for 15-30 seconds
then boot into Linux."
When from time to time and the few times it works that blank
screen fails to give a response letting users know it's working
after following the procedure in the instructions then waiting
out each attempt that failed over and over!
Any of you kind folks out there adept at it?...
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
